2

SCD8662 Rev G 4/24/12

Aeroflex Plainview

ABSOLUTE MAXIMUM RATINGS

PARAMETER

RANGE

UNITS

Input Voltage

DC Output Current

1.5

A

Lead temperature (soldering 10 Sec)

300

°C

Input Output Differential

25

Output Voltage

+25

ESD (MIL-STD-883, M3015, Class 3A)

4000

V

Operating Junction Temperature Range

-55 to +150

°C

Storage Temperature Range

-65 to +150

°C

NOTICE: Stresses above those listed under "Absolute Maximum Ratings" may cause permanent damage to the device. These are stress rating only;

functional operation beyond the "Operation Conditions" is not recommended and extended exposure beyond the "Operation Conditions"

may effect device reliability.

RECOMMENDED OPERATING CONDITIONS

PARAMETER

RANGE

UNITS

Output Voltage Range

1.275 to 23

Input Output Differential

1.5 to 25

Case Operating Temperature Range

-55 to +125

°C

ELECTRICAL PERFORMANCE CHARACTERISTICS

Unless otherwise specified, -55°C < Tc < +125°C.

PARAMETER

SYM

CONDITIONS (P

MIN

MAX

UNITS

Reference Voltage 2/ 3/

1.210

1.275

V

Line Regulation 2/ 3/

-0.25

%

-

0.40

%

-

1.30

V

Adjust Pin Current 2/

-

-

-

120

µA

Adjust Pin Current Change 2/-

-

5

µA

1.5

-

A

0.047

-

A

-

10

mA

Ripple Rejection 3/-

60

-

dB

Thermal Regulation

-

-

0.04

%/W

-

-

0.30

%

Thermal Resistance

(Junction to Case)

--

3

°C/W

Notes:

1/ For compliance with MIL-STD- 883 revision C current density specification, the RH1086MK is derated to 1 Amp but is capable of 1.5 Amps.

2/ Specification derated to reflect Total Dose exposure to 100 Krad (Si) @+25°C

3/ Line and load regulation are guaranteed up to the maximum power dissipation of 15W. Power dissipation is determined by the input/output

differential voltage and the output current. Guaranteed maximum power dissipation will not be available over the full input/output voltage range.

4/ Dropout voltage is specified over the full output current range of the device.

5/ Not tested. Shall be guaranteed by design, characterization, or correlation to other tested parameters.

6/ Pulsed @ <10% duty cycle @+25°C for characterization only. (See note 1)