AX88796 datasheet(49/71 Pages) ASIX

49 / 71 page

ASIX ELECTRONICS CORPORATION

AX88796 L

3-in-1 Local Bus Fast Ethernet Controller

5.2.16 MR30 –Device-Specific Register 3 (10Mbps Control) Bit Descriptions

FIELD

TYPE

DESCRIPTION

30.15 (Test10TX)

R/W

When high and 10Base-T is powered up, a continuous 10 MHz signal

(1111) will be transmitted. This is only meant for testing. Default 0.

30.14 (RxPLLEn)

R/W

When high, all 10Base-T logic will be powered up when the link is up.

Otherwise, portions of the logic will be powered down when no data is being

received to conserve power. Default is 0.

30.13 (JAB_DIS)

R/W

Jabber Disable. When this bit is 1, disables the jabber function of the

10Base-T receive. Default is 0.

30.12:7 (UNUSED)

R/W

Unused. Read as 0.

30.6 (LITF_ENH)

R/W

Enhanced Link Integrity Test Function. When high, function is enabled.

This is ORed with the LITF_ENH input. Default is 0.

30.5 (HBT_EN)

R/W

Heartbeat Enable. When this bit is a 1, the heartbeat function will be

enabled. Valid in 10Mbits/s mode only.

30.4 (ELL_EN)

R/W

Extended Line Length Enable. When this bit is a 1, the receive squelch

levels are reduced from a nominal 435 mV to 350 mV, allowing reception of

signals with a lower amplitude. Valid in 10Mbits/s mode only.

30.3 (APF_EN)

R/W

Autopolarity Function Disable. When this bit is a 0 and the PHY is in 10

Mbits/s mode, the autopolarity function will determine if the TP link is

wired with a polarity reversal.

If there is a polarity reversal, the PHY will assert the APS bit (register 28, bit

6) and correct the polarity reversal. If this bit is a 1 and the device is in 10

Mbits/s mode, the reversal will not be corrected.

30.2 (RESERVED)

R/W

Reserved.

30.1 (SERIAL _SEL)

R/W

Serial Select. When this bit is set to a 1, 10Mbits/s serial mode will be

selected. When the PHY is in 100Mbits/s mode, this bit will be ignored.

30.0 (ENA_NO_LP)

R/W

No Link Pulse Mode. Setting this bit to a 1 will allow 10Mbits/s operation

with link pulses disabled. If the PHY is configured for 100Mbits/s operation,

setting this bit will not affect operation.

AX88796 데이터시트(PDF) 49 Page - ASIX Electronics Corporation

AX88796 데이터시트(HTML) 49 Page - ASIX Electronics Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71

데이터시트 다운로드

링크 URL