UCC28704 datasheet(13/44 Pages) TI1

13 / 44 page

0 V

VS ring p-p

(scaled)

tDM_BLANK

tLK_RESET

tDMAG

tSW

Entering Wait State

IPP < IPP(max)

RS2/(RS1+RS2)

UCC28704

www.ti.com

SLUSCA8A – FEBRUARY 2016 – REVISED FEBRUARY 2016

Product Folder Links: UCC28704

Submit Documentation Feedback

Feature Description (continued)

The UCC28704 VS signal sampler includes signal discrimination methods to ensure an accurate sample of the

output voltage from the auxiliary winding. There are however critical details of the auxiliary winding signal to

ensure reliable operation, specifically the reset time of the leakage inductance and the duration of any

subsequent leakage inductance ring. Refer to Figure 14 for a detailed illustration of waveform criteria to ensure a

reliable sample on the VS pin. The first detail to examine is the duration of the leakage inductance reset

pedestal, TLK_RESET in Figure 14. Since this can mimic the waveform of the secondary current decay, followed by

a sharp downslope, it is important to keep the leakage reset time less than 750 ns for IPRI minimum, and less

than 3.0 µs for IPRI maximum. The second detail is the amplitude of ringing on the VAUX waveform following

tLK_RESET. The peak-to-peak voltage at the VS pin should be less than approximately 250 mVp-p at least 250 ns

before the end of the demagnetization time, tDMAG. If there is a concern with excessive ringing, it usually occurs

during light or no load conditions, when tDMAG is at the minimum, tDMAG(min). The tolerable ripple on VS is scaled

up to the auxiliary winding voltage by RS1 and RS2, and is equal to 250 mV × (RS1+RS2) / RS2. The snubber

designs can be designed to allow the ripple voltage to meeting these requirements.

As mentioned in Device Functional Modes, when IPP < IPP(max), the device operation enters a “Wait” state during

each switching cycle of its non-switching portion as shown in Figure 14. In the Wait state, the device bias current

changes to IWAIT (typical 70 µA) from IRUN (typical 2.3 mA), reducing its bias power to help boost efficiency at light

load and to reduce standby load power.

Figure 14. Auxiliary Waveform Details

UCC28704 데이터시트(PDF) 13 Page - Texas Instruments