|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||

||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||

2015-07-0019

PT0476-3

08/05/15

2

PI3CH480

4-Channel 2:1 Mux/DeMux, Enable Low

1.8V/2.5V/3.3V, High-Bandwidth, Hot Plug

Maximum Ratings

StorageTemperature...................................................................................-65oC to +150oC

Supply Voltage to Ground Potential............................................................-0.5V to + 4.6V

DC Input Voltage ............................................................................................-0.5V to + 6.0V

DC Output Current

Power Dissipation..............................................................................................................0.5W

DC Electrical Characteristics

Symbol

Description

Test Conditions

(1)

Min

Typ

(2)

Max

Unit

Control Input HIGH Voltage

Guaranteed Logic HIGH Level

2.0

-

-

V

Control Input LOW Voltage

Guaranteed Logic LOW Level

-0.5

-

0.8

V

Clamp Diode Voltage

-

-1.3

-1.8

V

Input HIGH Current

-

-

±1

μA

Input Low Current

-

-

±1

μA

High-Impedance Current

(3)

0 ≤ Y, In ≤ V

CC

-

-

±1

μA

Switch On-Resistance

(4)

-

4

6

Ω

-

5

8

Notes:

1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.

3. Not more than one output should be shorted at one time. Duration of the test should not exceed one second.

4. Measured by the voltage drop between Y and In pin at indicated current through the switch. ON resistance is determined by the lower of

the voltages on the two (Y, In) pins.

Symbol

Description

Test Conditions

(1)

Min

Typ

(2)

Max

Unit

Control Input HIGH Voltage

Guaranteed Logic HIGH Level

1.8

-

V

Control Input LOW Voltage

Guaranteed Logic LOW Level

-0.3

-

0.8

V

Clamp Diode Voltage

-

-0.7

-1.8

V

Input HIGH Current

-

-

±1

μA

Input Low Current

-

-

±1

μA

High-Impedance Current

(3)

0 ≤ Y, In ≤ V

CC

-

-

±1

μA

Switch On-Resistance

(4)

-

4

8

Ω

-

7

14

Notes:

1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.

3. Not more than one output should be shorted at one time. Duration of the test should not exceed one second.

4. Measured by the voltage drop between Y and In pin at indicated current through the switch. ON resistance is determined by the lower of

the voltages on the two (Y, In) pins.

Note:

Stresses greater than those listed under MAXIMUM

RATINGS may cause permanent damage to the

device. This is a stress rating only and functional

operation of the device at these or any other condi-

tions above those indicated in the operational sec-

tions of this specification is not implied. Exposure

to absolute maximum rating conditions for extended

periods may affect reliability.