BCM4354 datasheet(59/192 Pages) CYPRESS

59 / 192 page

I2S Interface

BCM4354 Data Sheet

BROADCOM CONFIDENTIAL

Broadcom®

October 15, 2014 • 4354-DS109-R

Page 58

I2S Interface

The BCM4354 supports two independent I2S digital audio ports: one for Bluetooth audio, and one for high-

fidelity FM audio. The I2S interface for FM audio supports both master and slave modes. The I2S signals are:

•I2S clock: BT_I2S_CLK

•I2S Word Select: BT_I2S_WS

•I2S Data Out: BT_I2S_DO

•I2S Data In: BT_I2S_DI

BT_I2S_CLK and BT_I2S_WS become outputs in master mode and inputs in slave mode, whereas BT_I2S_DO

always stays as an output. The channel word length is 16 bits, and the data is justified so that the MSB of the

left-channel data is aligned with the MSB of the I2S bus, in accord with the I2S specification. The MSB of each

data word is transmitted one bit clock cycle after the BT_I2S_WS transition, synchronous with the falling edge

of the bit clock. Left-channel data is transmitted when IBT_I2S_WS is low, and right-channel data is transmitted

when BT_I2S_WS is high. Data bits sent by the BCM4354 are synchronized with the falling edge of

BT_I2S_CLK and should be sampled by the receiver on the rising edge of BT_I2S_CLK.

The clock rate in master mode is either of the following:

48 kHz x 32 bits per frame = 1.536 MHz

48 kHz x 50 bits per frame = 2.400 MHz

The master clock is generated from the input reference clock using a N/M clock divider.

In the slave mode, any clock rate is supported to a maximum of 3.072 MHz.

BCM4354 데이터시트(PDF) 59 Page - Cypress Semiconductor