ABSOLUTE MAXIMUM RATINGS

(1)

ADS5273

This integrated circuit can be damaged by ESD. Texas Instruments recommends that all integrated circuits be handled with

appropriate precautions. Failure to observe proper handling and installation procedures can cause damage.

ESD damage can range from subtle performance degradation to complete device failure. Precision integrated circuits may be more

susceptible to damage because very small parametric changes could cause the device not to meet its published specifications.

SPECIFIED

PACKAGE

TEMPERATURE

PACKAGE

ORDERING

TRANSPORT

PRODUCT

DESIGNATOR

RANGE

MARKING

NUMBER

MEDIA, QUANTITY

ADS5273IPFP

Tray, 96

ADS5273

HTQFP-80

PFP

–40°C to +85°C

ADS5273IPFP

ADS5273IPFPT

Tape and Reel, 250

(1)

For the most current package and ordering information, see the Package Option Addendum at the end of this document or see the TI

web site at www.ti.com.

(2)

Thermal pad size: 4.69mm × 4.69mm (min), 6.20mm × 6.20mm (max).

Analog Supply Voltage Range, AVDD

–0.3V to +3.8V

Output Driver Supply Voltage Range, LVDD

–0.3V to +3.8V

Voltage Between AVSS and LVSS

–0.3V to +0.3V

Voltage Between AVDD and LVDD

–0.3V to +0.3V

Voltages Applied to External REF Pins

–0.3V to +2.4V

All LVDS Data and Clock Outputs

–0.3V to +2.4V

–0.3V to min. [3.3V, (AVDD + 0.3V)]

Digital Input Pins, Set 1 (pins 69, 76-78)

Digital Input Pins, Set 2 (pins 16, 45)

–40°C to +85°C

Lead Temperature, 1.6mm (1/16" from case for 10s)

+260°C

Junction Temperature

+105°C

Storage Temperature Range

–65°C to +150°C

(1)

Stresses above these ratings may cause permanent damage. Exposure to absolute maximum conditions for extended periods may

degrade device reliability. These are stress ratings only, and functional operation of the device at these or any other conditions beyond

those specified is not supported.

(2)

The dc voltage applied on the input pins should not go below –0.3V. Also, the dc voltage should be limited to the lower of either 3.3V or

(AVDD + 0.3V). If the input can go higher than +3.3V, then a resistor greater than or equal to 25

Ω should be added in series with each

of the input pins. Also, the duty cycle of the overshoot beyond +3.3V should be limited. The overshoot duty cycle can be defined either

as a percentage of the time of overshoot over a clock period, or over the entire device lifetime. For a peak voltage between +3.3V and

+3.5V, a duty cycle up to 10% is acceptable. For a peak voltage between +3.5V and +3.7V, the overshoot duty cycle should not exceed

1%. Any overshoot beyond +3.7V should be restricted to less than 0.1% duty cycle, and never exceed +3.9V.

(3)

It is recommended that a series resistor of 1k

Ω or greater be used if the digital input pins are tied to AVDD or LVDD.

2

Submit Documentation Feedback

Copyright © 2004–2009, Texas Instruments Incorporated

Product Folder Link(s): ADS5273