TAS5100

SLLS419B − MARCH 2001 − REVISED NOVEMBER 2001

6

www.ti.com

Terminal Functions

TERMINAL

I/O

DESCRIPTION

NAME

NO.

I/O

DESCRIPTION

BIAS_A

11

I

Connect external resistor to DVSS. See application note SLAA117

BIAS_B

12

I

Connect external resistor to DVSS. See application note SLAA117

BOOTSTRAPA

30

O

Bootstrap capacitor pin for H-bridge A

BOOTSTRAPB

19

O

Bootstrap capacitor pin for H-bridge B

DVDD

6

I

3.3-V digital voltage supply for logic

DVSS

7, 8, 9

I

Digital ground for logic is internally connected to PVSS. All three pins must be tied together but not

connected externally to PVSS. See Figure 5.

ERR1

3

O

Error/warning report indicator. This output is open drain with internal pullup resistor.

ERR0

4

O

Error/warning report indicator. This output is open drain with internal pullup resistor.

LDROUTA

31

O

Low voltage drop-out regulator output A (not to be used to supply current to external circuitry)

LDROUTB

18

O

Low voltage drop-out regulator output B (not to be used to supply current to external circuitry)

OUTPUTA

26, 27

O

H-bridge output A

OUTPUTB

22, 23

O

H-bridge output B

PVDDA1

28, 29

I

High voltage power supply, H-bridge A

PVDDA2

32

I

High voltage power supply for low-dropout voltage regulator A-side

PVDDB1

20, 21

I

High voltage power supply, H-bridge B

PVDDB2

17

I

High voltage power supply for low-dropout voltage regulator B-side

PVSS

24, 25

I

High voltage power supply ground

PWDN

13

I

Power down = 0, normal mode = 1

PWM_AP

1

I

PWM input A(+)

PWM_AM

2

I

PWM input A(−)

PWM_BP

16

I

PWM input B(+)

PWM_BM

15

I

PWM input B(−)

RESET

14

I

Reset and mute mode = 0, normal mode = 1, when in reset mode, H-bridge MOSFETs are in low-low

output state. Asserting the RESET signal low causes all fault conditions to be cleared.

SHUTDOWN

5

O

Device is in shutdown due to fault condition, normal mode = 1, shutdown = 0, when device is in

shutdown mode the H-bridge MOSFETs are in low-low output state. The latched output can be

cleared by asserting the RESET signal. This output is open drain with internal pullup resistor.

VRFILT

10

O

A filter capacitor must be added between VRFILT and DVSS pins.

NOTE: The four PWM inputs: PWM_AP, PWM_AM, PWM_BP, and PWM_BM must always be connected to the TAS5000 output pins, and never

left floating. Floating PWM input pins will cause an illegal PWM input state signal to be asserted.

Dual pins: OUTPUTA, OUTPUTB, PVDDA1 and PVDDB1 must have both pins connected externally to the same point on the circuit board,

respectively. Both PVSS pins must also be connected together externally. These multiple pins are for the high current DMOS output

devices. Failure to connect all the multiple pins to the same respective node will result in excessive current flow in the internal bond wires

and can cause the device to fail. All electrical characteristics are specified and measured with all of the multiple pins connected to the same

node, respectively.