SL811HS
Document #: 38-08008 Rev. *A
Page 12 of 29
5.2.8
USB-A/USB-B Host Transfer Count Register (Read), USB Address (Write) [04H, 0CH]
This register has two functions. When read, this register contains the number of bytes left over (from “Length” field) after a packet
is transferred. If an overflow condition occurs, i.e., the received packet from slave USB device was greater than the Length field
specified, a bit is set in the Packet Status Register indicating the condition. When written, this register will contain the USB Device
Address to which the Host wishes to communicate.
DA6-DA0
Device address, up to 127 devices can be addressed
DA7
Reserved bit should be set zero.
5.3
SL811HS Control Registers
5.3.1
Control Register 1, Address [05H]
The Control Register 05H enables/disables USB transfer operation with control bits defined as follows.
• At power-up this register will be cleared to all zeros.
• In the SL811HS, bit 0 is used to enable HW SOF auto-generation (bit 0 was not used in the SL11H).
D7
D6
D5
D4
D3
D2
D1
D0
0
DA6
DA5
DA4
DA3
DA2
DA1
DA0
Register Name SL11H and SL811H
SL11H (hex) Address
SL811HS (hex) Address
Control Register1
05H
05H
Interrupt Enable Register
06H
06 H
Reserved Register
07H
07 H
Status Register
0DH
0DH
SOF Counter LOW (Write)/HW Revision Register (Read)
0EH
0E H
SOF Counter HIGH and Control Register2
Reserved
0F H
Memory Buffer
10H-FFH
10H-FFH
Bit
Bit Name
Function
0
SOF ena/dis
“1” enable auto Hardware SOF generation, “0”= disable
1
Reserved
2
Reserved
3
USB Engine Reset
USB Engine reset = “1.” Normal set “0”
4
J-K state force
See the table below
5
USB Speed
“0” set-up for full speed, “1” set-up LOW-SPEED
6
Suspend
“1” enable, “0” = disable
7
Reserved
Korean ▼
English
Chinese
German
Japanese
Russian
Korean
Spanish
French
Italian
Portuguese
Polish
Vietnamese
Indian
Mexican
British
New Zealand
