LF412 datasheet(4/13 Pages) NSC

4 / 13 page

AC Electrical Characteristics (Continued)

(Note 7)

Symbol

Parameter

Conditions

LF412A

LF412

Units

Min

Typ

Max

Min

Typ

Max

THD

Total Harmonic Dist

V=+10, RL=10k,

O=20 Vp-p,

BW=20 Hz-20 kHz

≤0.02

Equivalent Input Noise

A=25˚C, RS=100

Ω,25

Voltage

f=1 kHz

Equivalent Input Noise

A=25˚C, f=1 kHz

0.01

Current

Note 3: Unless otherwise specified the absolute maximum negative input voltage is equal to the negative power supply voltage.

Note 4: Any of the amplifier outputs can be shorted to ground indefintely, however, more than one should not be simultaneously shorted as the maximum junction

temperature will be exceeded.

Note 5: For operating at elevated temperature, these devices must be derated based on a thermal resistance of

θjA.

Note 6: These devices are available in both the commercial temperature range 0˚C

≤TA≤70˚C and the military temperature range −55˚C≤TA≤125˚C. The

temperature range is designated by the position just before the package type in the device number. A “C” indicates the commercial temperature range andan“M”

indicates the military temperature range. The military temperature range is available in “H” package only. In all cases the maximum operating temperature is limited

by internal junction temperature Tj max.

Note 7: Unless otherwise specified, the specifications apply over the full temperature range and for VS=±20V for the LF412A and for VS=±15V for the LF412. VOS,

IB, and IOS are measured at VCM=0.

Note 8: The LF412A is 100% tested to this specification. The LF412 is sample tested on a per amplifier basis to insure at least 85% of the amplifiers meet this

specification.

Note 9: The input bias currents are junction leakage currents which approximately double for every 10˚C increase in the junction temperature, Tj. Due to limited

production test time, the input bias currents measured are correlated to junction temperature. In normal operation the junction temperature rises above the ambient

temperature as a result of internal power dissipation, PD.Tj=TA+θjA PD where θjA is the thermal resistance from junction to ambient. Use of a heat sink is

recommended if input bias current is to be kept to a minimum.

Note 10: Supply voltage rejection ratio is measured for both supply magnitudes increasing or decreasing simultaneously in accordance with common practice. VS

= ±6V to ±15V.

Note 11: Refer to RETS412X for LF412MH and LF412MJ military specifications.

Note 12: Max. Power Dissipation is defined by the package characteristics. Operating the part near the Max. Power Dissipation may cause the part to operate

outside guaranteed limits.

Note 13: Human body model, 1.5 k

Ω in series with 100 pF.

Typical Performance Characteristics

Input Bias Current

00565610

00565611

LF412 데이터시트(PDF) 4 Page - National Semiconductor (TI)

LF412 데이터시트(HTML) 4 Page - National Semiconductor (TI)

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13

데이터시트 다운로드

링크 URL