AS & ASE

■ Bracket Installation Procedure

■Handling Precautions (AS and ASE Series)

1.Soldering SpeciÄcations

⑴Manual Soldering

Device

： Soldering iron

380

℃, Max.; 3 seconds, Max.

⑵Auto Soldering

Device

： Jet wave type or dip type

275

℃, Max.; 6 seconds, Max.

・Pre-heating should be done at temperatures ranging from 80℃

to 120

℃ and within 120 sec.

2. Flux Cleaning

⑴Solvent : Fluorine or Alcohol type.

⑵Cleaning after soldering should be done after the terminal

temperature falls to 90

℃ or below, or after leaving the switch

for Äve minutes or longer at room temperature.

AS series are not process sealed and are not washable. If the PC

board is to be cleaned, clean the soldering surface of substrate with

a brush so that the switch is not exposed to the cleaning solution.

⑶Do not use ultrasonic cleaning system.

3. Mounting of Switch

⑴Use the PC boards of φ1 holes.

⑵Do not bend the terminals before mounting the switch on the

PC board.

⑶After mounting the switch, do not place the device in such a

way that the device weight will be applied on the knob, etc.

of the switch.

⑷Do not apply load exceeding 12.7 N (1.3 kgf) to the knob.

Use a bracket (optional accessory) if the load is expected

to exceed 12.7 N (1.3 kgf). The strength of the knob will be

reinforced to 29.4 N (3 kgf) max..

■Packaging SpeciÄcations

Plastick Pack

Right-angle terminals

: 50 pcs/pack

PC terminals

：100 pcs/pack