2

N.FL Series

■Specifications

Item

Specification

Conditions

1. Contact resistance

10 mA max.

2. Insulation resistance

500 M ohms min.

100V DC

3. Withstanding voltage

No flashover or insulation breakdown

200V AC / 1 minute

4. V.S.W.R.(Note)

1.3max.

DC to 6GHz

5. Durability

20 cycles

6. Vibration

7. Shock

8. Humidity

96 hours at +40°C, and humidity of 95%

9. Temperature cycle

No damage, cracks, or parts dislocation

10. Salt spray test

No excessive corrosion

5% salt water solution, 48 hours

Waveform: sine half-wave, 3 cycles in each of the

3 axis

Time: 30 min./ 5 min. max. / 30 min. / 5 min. max.

5 cycles

Frequency: 10 to 100 Hz, single amplitude of 1.5 mm

5 cycles

Contact resistance

Center contact: 30 m ohms max.

Outer contact: 30 m ohms max.

No damage, cracks, or parts dislocation

No electrical discontinuity of 1 μs or longer

No damage, cracks, or parts dislocation

No electrical discontinuity of 1 μs or longer

No damage, cracks, or parts dislocation

Insulation resistance: 100 M ohms min. (high humidity)

Insulation resistance: 500 M ohms min. (dry)

No damage, cracks, or parts dislocation

Center contact: 25 m ohms max.

Outer contact: 25 m ohms max.

Nominal characteristic impedance

Frequency range

50 ohms

DC to 6 GHz

Operating temperature range

Storage temperature range

-40°C to +90°C (90% RH)

-30°C to +70°C (90% RH)

Ratings

Note: Information contained in this catalog represents general requirements for this Series. Contact us for the drawings and specifications for a

specific part number shown.

* V.S.W.R. Measurement System

Measured as shown on the block diagram below.

■Materials / Finishes

Note1: A N.FL Cable assembly (plug) is measured with SMA conversion

adapters mated with N.FL plugs at both ends of a 100cm coaxial cable

harness

Note2: A N.FL receptacle, which is mounted on a 50 ohms glass epoxy board,

is measured with a SMA conversion adapter.

Network Analyzer

Test Set

Test Port

Termination

D.U.T

Test Port Cable

Shell

Phosphor bronze

Silver plated

-------

Female center contact

Phosphor bronze

Gold plated

-------

Insulator

PBT

Color: Black

UL94V-0

Part

Material

Finish

Remarks

●Plug

●Receptacle

Shell

Phosphor bronze

Silver plated

-------

Male center contact

Brass

Gold plated

-------

Insulator

LCP

Color: Black

UL94V-0

Part

Material

Finish

Remarks

The product information in this catalog is for reference only. Please request the Engineering Drawing for the most current and accurate design information.

All non-RoHS products have been discontinued, or will be discontinued soon. Please check the products status on the Hirose website RoHS search at www.hirose-connectors.com, or contact your Hirose sales representative.