MSC1211 datasheet(51/105 Pages) TI

51 / 105 page

MSC1211, MSC1212

MSC1213,MSC1214

SBAS323D − JUNE 2004 − REVISED SEPTEMBER 2005

www.ti.com

Timer/Counter Control (TCON)

Reset Value

SFR 88h

TF1

TR1

TF0

TR0

IE1

IT1

IE0

IT0

00h

TF1

Timer 1 Overflow Flag. This bit indicates when Timer 1 overflows its maximum count as defined by the current mode.

bit 7

This bit can be cleared by software and is automatically cleared when the CPU vectors to the Timer 1 interrupt service

routine.

0: No Timer 1 overflow has been detected.

1: Timer 1 has overflowed its maximum count.

TR1

Timer 1 Run Control. This bit enables/disables the operation of Timer 1. Halting this timer preserves the current

bit 6

count in TH1, TL1.

0: Timer is halted.

1: Timer is enabled.

TF0

Timer 0 Overflow Flag. This bit indicates when Timer 0 overflows its maximum count as defined by the current mode.

bit 5

This bit can be cleared by software and is automatically cleared when the CPU vectors to the Timer 0 interrupt service

routine.

0: No Timer 0 overflow has been detected.

1: Timer 0 has overflowed its maximum count.

TR0

Timer 0 Run Control. This bit enables/disables the operation of Timer 0. Halting this timer preserves the current

bit 4

count in TH0, TL0.

0: Timer is halted.

1: Timer is enabled.

IE1

Interrupt 1 Edge Detect. This bit is set when an edge/level of the type defined by IT1 is detected. If IT1 = 1, this bit

bit 3

will remain set until cleared in software or the start of the External Interrupt 1 service routine. If IT1 = 0, this bit will

inversely reflect the state of the INT1 pin.

IT1

Interrupt 1 Type Select. This bit selects whether the INT1 pin will detect edge or level triggered interrupts.

bit 2

0: INT1 is level-triggered.

1: INT1 is edge-triggered.

IE0

Interrupt 0 Edge Detect. This bit is set when an edge/level of the type defined by IT0 is detected. If IT0 = 1, this bit

bit 1

will remain set until cleared in software or the start of the External Interrupt 0 service routine. If IT0 = 0, this bit will

inversely reflect the state of the INT0 pin.

IT0

Interrupt 0 Type Select. This bit selects whether the INT0 pin will detect edge or level triggered interrupts.

bit 0

0: INT0 is level-triggered.

1: INT0 is edge-triggered.

MSC1211 데이터시트(PDF) 51 Page - Texas Instruments

MSC1211 데이터시트(HTML) 51 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL