PI2127 datasheet(13/19 Pages) VICOR

13 / 19 page



Picor Corporation • picorpower.com

PI2127

Rev 1.3

Page 13 of 19

happens, the MOSFET is turned on and the

FT pin

will be high resistance to indicate that the MOSFET is

in RDS(on) with no fault conditions existing.

Note that in case of an input fault condition, where the

S pin is at ground and the output (D pin and SN pin)

are at a high voltage there will be two current paths,

one path from D pin to GND and the other path from

SN pin to SP.

The current path from D pin to GND and S pins is due

to the level shift circuit and will draw current from the

output as a function of the voltage between D pin and

GND (VD-GND) based on the following equation:

−

GND

FLT

Where:

FLT

−

Maximum D pin current during input short

fault condition

GND

−

: Voltage difference between the D pin and

ground.

The current path from SN pin to S pin is a function of

the SN voltage based on the following equation:

PAR

GND

FLT

−

Where:

FLT

: SN current during input short fault condition

GND

−

: Voltage difference between SN pin (or load

voltage) and ground.

PAR

Resistance of the internal path, 10KΩ

typical and 8kΩ minimum

The level shift circuit worst case power dissipation

during input short is:

−

GND

)

(

The thermal resistance and power dissipation of the

level shift circuit will limit the voltage applied at the D

pin during a shorted input condition. When the PCB

temperature exceeds 110°C, the applied voltage must

be derated according to Figure 21. The plot in Figure

21 is calculated using the worst case power

dissipation during an input short with RθJ-PCB=

100°C/W.

Figure 21: Level shift circuit applied voltage de-rating

(valid during an input short fault condition

as a function of PCB Temperature)

PI2127 데이터시트(PDF) 13 Page - Vicor Corporation

PI2127 데이터시트(HTML) 13 Page - Vicor Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19

데이터시트 다운로드

링크 URL