LPS22HBTR datasheet(17/49 Pages) STMICROELECTRONICS

17 / 49 page

DocID027083 Rev 5

17/49

LPS22HB

FIFO

The LPS22HB embeds 32 slots of 40-bit data FIFO to store the pressure and temperature

output values. This allows consistent power saving for the system, since the host

processor does not need to continuously poll data from the sensor, but it can wake up only

when needed and burst the significant data out from the FIFO. This buffer can work

according to seven different modes: Bypass mode, FIFO mode, Stream mode, Dynamic-

Stream mode, Stream-to-FIFO mode, Bypass-to-Stream and Bypass-to-FIFO mode. The

FIFO buffer is enabled when the FIFO_EN bit in CTRL_REG2 (11h) is set to '1' and each

mode is selected by the FIFO_MODE[2:0] bits in FIFO_CTRL (14h). Programmable FIFO

threshold status, FIFO overrun events and the number of unread samples stored are

available in the FIFO_STATUS (26h) register and can be set to generate dedicated

interrupts on the INT_DRDY pad using the CTRL_REG3 (12h) register.

FIFO_STATUS (26h)(FTH_FIFO) goes to '1' when the number of unread samples

(FIFO_STATUS (26h)(FSS5:0)) is greater than or equal to WTM[4:0] in FIFO_CTRL (14h).

If FIFO_CTRL (14h)(WTM4:0) is equal to 0, FIFO_STATUS (26h)(FTH_FIFO) goes to '0'.

FIFO_STATUS (26h)(OVRN) is equal to '1' if a FIFO slot is overwritten.

FIFO_STATUS (26h)(FSS5:0) contains stored data levels of unread samples; when

FSS[5:0] is equal to '000000' FIFO is empty, when FSS[5:0] is equal to '100000' FIFO is full

and the unread samples are 32.

To guarantee the switching into and out of FIFO mode, discard the first sample acquired.

5.1

Bypass mode

In Bypass mode (FIFO_CTRL (14h)(FMODE2:0)=000), the FIFO is not operational and it

remains empty.

Bypass mode is also used to reset the FIFO when in FIFO mode.

As described in the next figure, for each channel only the first address is used. When new

data is available, the older data is overwritten.

Figure 7. Bypass mode

LPS22HBTR 데이터시트(PDF) 17 Page - STMicroelectronics