SST49LF080A datasheet(7/50 Pages) MICROCHIP

7 / 50 page

DS20005086B

11/14

8 Mbit LPC Flash

SST49LF080A

Data Sheet

Design Considerations

SST recommends a high frequency 0.1 µF ceramic capacitor to be placed as close as possible

between VDD and VSS less than 1 cm away from the VDD pin of the device. Additionally, a low fre-

quency 4.7 µF electrolytic capacitor from VDD to VSS should be placed within 5 cm of the VDD pin. If you

use a socket for programming purposes add an additional 1-10 µF next to each socket.

Product Identification

The Product Identification mode identifies the device as the SST49LF080A and manufacturer as SST.

Mode Selection

The SST49LF080A flash memory devices can operate in two distinct interface modes: the LPC mode

and the Parallel Programming (PP) mode. The mode pin is used to set the interface mode selection. If

the mode pin is set to logic High, the device is in PP mode. If the mode pin is set Low, the device is in

the LPC mode. The mode selection pin must be configured prior to device operation. The mode pin is

internally pulled down if the pin is left unconnected. In LPC mode, the device is configured to its host

using standard LPC interface protocol. Communication between Host and the SST49LF080A occurs

via the 4-bit I/O communication signals, LAD [3:0] and LFRAME#. In PP mode, the device is pro-

grammed via an 11-bit address and an 8-bit data I/O parallel signals. The address inputs are multi-

plexed in row and column selected by control signal R/C# pin. The row addresses are mapped to the

lower internal addresses (A10-0), and the column addresses are mapped to the higher internal

addresses (AMS-11). See Figure 4, the Device Memory Map, for address assignments.

Table 2: Product Identification

Address

Data

Manufacturer’s ID

0000H

BFH

Device ID

SST49LF080A

0001H

5BH

T2.0 25026

SST49LF080A 데이터시트(PDF) 7 Page - Microchip Technology