408- 10373

SMPM Floating Panel Mount, Cable Jacks (Direct Solder Attachment) 1996390- 1, 1996771- 1

Rev B

2

of 2

Tyco Electronics Corporation

2. Insert compression spring in module mounting

hole and over connector body from the module

mating face.

3. Place retaining washer into insertion tool

2101595--1 aligning the flats on the tool with the

external flats on the washer.

4. Align the internal retaining washer flats with the

external flats on the connector body using the

alignment slots on the connector flange and on the

insertion tool. See Figure 5.

5. Insert the retaining washer into the module, over

the connector body compressing the spring until

the insertion tool bottoms on the module mating

face.

6. Lock the retaining washer into position by

rotating the insertion tool 90 while applying light

pressure on the tool. (The tool will spring back

about 0.51 mm [.020 in.] from the module face

when washer is in proper position. A correct

installation of the retaining washer will result in a

dimension of 3.22 mm [.127 in.] from front of

module. See Figure 6.

Safety glasses should be worn when installing

the retaining washer since they are spring--loaded

and could potentially fly out of the module. This

action could inflict eye injury to personnel if the

retaining washer is not properly seated during

installation.

5. REPLACEMENT AND REPAIR

The cable plug is not repairable. DO NOT use any

defective or damaged cable plugs.

6. REVISION SUMMARY

S

Updated document to corporate requirements

S

Changed “Retaining Ring” to Retaining

Washer” in all instances

S

Added text to Paragraphs 4.1, 4.2, and 4.5

S

Added new Figure 6

Figure 5

Cable

Connector

Flange

Module Mating Face

Compression Spring

Retaining Washer

Insertion Tool

Alignment Slot

Alignment Slot

Figure 6

3.23 [.127] Correct

Washer Installation

3.86 [.152] Wrong

Washer Installation

0.64 [.025] Height Delta

CAUTION

!