408- 10055

Removal Tools 1804171- 1, 1804173- 1, and 1804174- 1

Rev B

2

of 2

Tyco Electronics Corporation

2. Slide the removal tool onto the front of the

header so that the blades fit over the header

ground shields. See Figure 3, Detail A.

3. Push the removal tool straight into the header

until the blades butt against the housing.

Straighten the puller so that the teeth of the puller

fit over the back edge of the housing. See

Figure 3, Detail B.

4. Hold the puller in place, and tighten the

thumbscrew knob.

5. Slowly pull the lever away from the pc board

until the pushers butt against the pc board. Make

sure that the removal tool moves straight. DO NOT

allow the removal tool to tilt. See Figure 3,

Detail C.

Detail A

Detail B

Figure 3

Ground

Shields

Blades

Teeth of Puller

Over Back Edge

of Housing

Puller

Detail C

Housing

Pusher (2 Places)

Against PC Board

PC Board

Header

Pull Lever

6. Pull the removal tool (with the housing) straight

away from the header. DO NOT tilt the removal

tool.

7. Loosen the thumbscrew knob, and lower the

puller away from the housing.

8. Pull the housing from the removal tool.

5. MAINTENANCE

It is recommended that each operator be made aware

of, and responsible for, the following steps of daily

maintenance:

1. Remove dust, moisture, and other contaminants

from the removal tool with a clean, soft brush, or

lint--free cloth. DO NOT use objects that could

damage the removal tool.

2. When the removal tool is not in use, store it in a

clean, dry area.

6. REPLACEMENT AND REPAIR

Order removal tools through your representative, or

call 1--800--526--5142, or send a facsimile of your

purchase order to 717--986--7605, or write to:

CUSTOMER SERVICE (038--035)

TYCO ELECTRONICS CORPORATION

PO BOX 3608

HARRISBURG PA 17105--3608

For customer repair service, call 1--800--526--5136.

7. REVISION SUMMARY

Revisions to this instruction sheet include:

S

Updated instruction sheet to corporate

requirements