The following specifications apply for V

Symbol

Parameter

Conditions

LM4811

Units

(Limits)

Typical

(Note 4)

Limit

(Note 5)

Shutdown Attenuation

Shutdown mode active

−75

dB

Note 1: Absolute Maximum Ratings indicate limits beyond which damage to the device may occur.

Note 2: Operating Ratings indicate conditions for which the device is functional, but do not guarantee specific performance limits. For guaranteed specifications and

test conditions, see the Electrical Characteristics. The guaranteed specifications apply only for the test conditions listed. Some performance characteristics may

degrade when the device is not operated under the listed test conditions.

Note 3: Human body model, 100pF discharged through a 1.5k

Ω resistor.

Note 4: Typical specifications are specified at +25˚C and represent the most likely parametric norm.

Note 5: Tested limits are guaranteed to National’s AOQL (Average Outgoing Quality Level). Datasheet min/max specification limits are guaranteed by design, test,

or statistical analysis.

Note 6: : Machine Model ESD test is covered by specification EIAJ IC-121-1981. A 200pF cap is charged to the specified voltage, then discharged directly into the

IC with no external series resistor (resistance of discharge path must be under 50 Ohms).

Note 8: All voltages are measured with respect to the ground pin, unless otherwise specified.

External Components Description

(Figure 1)

Components

Functional Description

1. C

i

This is the input coupling capacitor. It blocks the DC voltage at, and couples the input signal to, the

amplifier’s input terminals. C

1/(2

πR

Ω. Refer to the section, Proper Selection of External

Components, for an explanation of how to determine the value of C

2. C

S

This is the supply bypass capacitor. It provides power supply filtering. Refer to the Application

Information section for proper placement and selection of the supply bypass capacitor.

3. C

B

This is the BYPASS pin capacitor. It provides half-supply filtering. Refer to the section, Proper

Selection of External Components, for information concerning proper placement and selection of C

4. C

O

This is the output coupling capacitor. It blocks the DC voltage at the amplifier’s output and it forms a

high pass filter with R

πR

Typical Performance Characteristics

THD+N vs Frequency

THD+N vs Frequency

20006103

20006104

www.national.com

5