408-6788

6 of 12

Rev L

Figure 7

2. Place the connector and cable inside the tool

locator, making sure that:

— the center conductor of center contact enters the

locator hole

— the connector is seated squarely on the locator

— if crimping a panel jack to the cable, the sides of

the panel jack should align with the tool jaws as

shown in Figure 9

3. Support the cable-and-connector assembly, and

squeeze the tool handles to complete the crimp as

shown in Figure 9.

6.2. For Connectors with Retractable Collars

Connectors with sliding coupling nuts (shown in Figure

10) require Special Die Set 312962-1 which is not

included in the kit and MUST be ordered separately.

Proceed as follows:

1. Slide the nut then the connector body, flange end

first, onto the cable.

2. Place the connector body and cable inside the

tool locator, making sure that the center conductor

enters the locator hole, and that the coupling nut is

positioned above the tool head.

Figure 8

Tool Setup

Die-Holding Hex Head

Screws (Captive)

Detail A

Detail B

Locator Locking

Screw (Ref)

Chamfer

Chamfer

Locator

(Typ)

Slip Cable in Locator

Between Dies. Tighten

Screws While Cable Holds

Dies in Proper Alignment

Center Conductor

of Connector Must

Enter Hole in

Locator

Crimping Connectors with Fixed Collars

(Except Right-Angle Connectors)

Connector with

Fixed Collar

Dies will Close Against

Cable and Connector to

Complete Termination