| 전자부품 데이터시트 검색엔진 |
|
P89682K 데이터시트(PDF) 39 Page - Aplus Intergrated Circuits |
|
|
|||||||||||||||||||||||||||||
P89682K 데이터시트(HTML) 39 Page - Aplus Intergrated Circuits |
|
39 / 44 page ![]() Integrated Circuits Inc. aP89682K/341K/170K/085K Ver 2.5.1 39 May 24 2016 I2C Mode Fig. 37 Note: 1. If voltage is higher than 4.0V, C (0.1uF(typ)) is necessary for endure high voltage and protect it from noise which may affect its performance. Distance between caps and ICs should be minimized to reduce spreading inductance. The wiring length between the IC and caps may be less than 150mil. 2. Rp is used to filter noise from power line. A. Rp is unnecessary in DAC mode or VDD less than 3.6v. The value of Rp is 0 ohm in DAC mode. B. If voltage is higher than 3.6V and chip is configured as PWM mode, Rp is necessary for system stability. The value of Rp is 56 ohm in PWM mode. The minimum operating voltage would be lifted from 2.0v to 2.2v, when Rp is added. C. If Rp is added and there are LED drove by OUT[1:3] pin, please configure the OUT pin as active low to drive LED. |
|
링크 URL |
| ALLDATASHEET 가 귀하에 도움이 되셨나요? [ DONATE ] |
Alldatasheet는? | 광고문의 | 운영자에게 연락하기 | 개인정보취급방침 | 링크 투 데이터시트 | 링크교환 | 제조사별 검색 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |