WM8750LEFLSLASHR datasheet(45/56 Pages) WOLFSON

45 / 56 page

Product Preview

WM8750L

PP Rev 1.77 May 2003

SAVING POWER BY REDUCING OVERSAMPLING RATE

The default mode of operation of the ADC and DAC digital filters is in 128x oversampling mode.

Under the control of ADCOSR and DACOSR the oversampling rate may be halved. This will result in

a slight decrease in noise performance but will also reduce the power consumption of the device.

ADDRESS

BIT

LABEL

DEFAULT

DESCRIPTION

ADCOSR

ADC oversample rate select

1 = 64x (lowest power)

0 = 128x (best SNR)

R24 (18h)

Additional Control

(2)

DACOSR

DAC oversample rate select

1 = 64x (lowest power)

0 = 128x (best SNR)

Table 42 ADC and DAC Oversampling Rate Selection

SAVING POWER AT LOW SUPPLY VOLTAGES

The analogue supplies to the WM8750L can run from 1.8V to 3.6V. By default, all analogue circuitry

on the device is optimized to run at 3.3V. This set-up is also good for all other supply voltages down

to 1.8V. However, at lower voltages, it is possible to save power by reducing the internal bias

currents used in the analogue circuitry. This is controlled as shown below.

ADDRESS

BIT

LABEL

DEFAULT

DESCRIPTION

R23 (17h)

Additional

Control(1)

7:6

VSEL

[1:0]

Analogue Bias optimization

00: Lowest bias current, optimized for AVDD=1.8V

01: Low bias current, optimized for AVDD=2.5V

1X: Default bias current, optimized for AVDD=3.3V

WM8750LEFL/R 데이터시트(PDF) 45 Page - Wolfson Microelectronics plc

WM8750LEFL/R 데이터시트(HTML) 45 Page - Wolfson Microelectronics plc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56

데이터시트 다운로드

링크 URL