408-1535

Rev T

5 of 7

HAND

TOOL

GAGE ELEMENT DIMENSIONS

HAND

TOOL

GAGE ELEMENT DIMENSIONS

GO

NO-GO

“R” (Radius)

GO

NO-GO

“W” (Width) Max

46673

46673-1

1.499-1.506

[.0590-.0593]

1.648-1.651

[.0649-.0650]

1.57 [.062]

46673

46673-1

0.762-0.770

[.0300-.0303]

1.267-1.270

[.0499-.0500]

3.05 [.120]

46988

1.702-1.709

[.0670-.0673]

1.851-1.854

[.0729-.0730]

46988

1.016-1.024

[.0400-.0403]

1.521-1.524

[.0599-.0600]

Figure 7

To gage the crimping chamber, proceed as follows:

1. Remove traces of oil or dirt from the crimping chamber and plug gages.

2. Remove locator assembly.

CAUTION

DO NOT lost spring in locator assembly.

3. Close the tool handles until the crimping jaws have bottomed. Do NOT force jaws beyond initial

contact.

4. Align the GO element with the wire barrel section of the crimping chamber. Push element straight into

the crimping chamber without using force. The GO element must pass completely through the

crimping chamber. See Figure 8.

Figure 8

5. Align the NO-GO element and try to insert it straight into the same section of the crimping chamber.

The NO-GO element may start entry, but must not pass completely through the crimping chamber.

See Figure 8.

6. Re-install locator assembly.

7. Insert tool insulation crimping adjustment pins into Position 1.

GO

Dim.

GO

Dim.

NO-GO

Dim.

NO-GO

Dim.

“W”

“W”

12.7 [.50]

Min. Typ

6.35 [.250]

Min. Typ

50.8 [2.00]

Min. Typ

Inspection of Wire

Barrel Section of

Crimping Chamber

Inspection of Insulation

Barrel Section of

Crimping Chamber

GO Element Must Pass Completely

Through Crimping Chamber

NO-GO Element May Start Entry, But Must Not

Pass Completely Through Crimping Chamber

Jaws Bottomed

But Not Under

Pressure