114-1008

Rev K1

11 of 11

6. VISUAL AID

The illustration below shows a typical application of .058 and .093 diameter pc board pins and disconnect

receptacle contacts. This illustration should be used by production personnel to ensure a correctly applied

product. Applications which do not appear correct should be inspected using the information in the preceding

pages of this specification and in the instructional material shipped with the product or tooling.

FIGURE 11. VISUAL AID

WIRE BARREL SEAM MUST BE CLOSED

AND CONTAIN ALL WIRE STRANDS

WIRE INSULATION MUST NOT

ENTER WIRE BARREL

FRONT AND REAR BELLMOUTHS MUST BE VISIBLE

AND MEET DIMENSIONAL REQUIREMENTS

BOTH WIRE CONDUCTORS AND INSULATION MUST BE

BETWEEN INSULATION BARREL AND WIRE BARREL

CUTOFF TAB AND BURR MUST MEET

DIMENSIONAL REQUIREMENTS

END OF WIRE MUST BE FLUSH WITH OR EXTEND

SLIGHTLY BEYOND FRONT OF WIRE BARREL

THERE MUST BE NO

DAMAGE TO MATING END

RECEPTACLE CONTACT CRIMP

WIRE BARREL AND INSULATION BARREL

CRIMP HEIGHT AND WIDTH MUST MEET

DIMENSIONAL REQUIREMENTS

WIRE BARREL FLASH MUST MEET

DIMENSIONAL REQUIREMENTS

RECEPTACLE CONTACT MUST

BE STRAIGHT WITHIN BEND

ALLOWANCE

CLINCH PIN

LEG PROTRUSION AND

WIDTH OF LEGS MUST

MEET REQUIREMENTS

PIN MUST NOT BE

LOOSE NOR ROTATE

PRESS FIT PIN

BEAD MUST BE

IN CONTACT WITH PC BOARD

PIN MUST BE

PERPENDICULAR

TO PC BOARD BY

NO MORE THAN 5°

SOLDER FILLETS MUST

BE EVENLY FORMED

AROUND EACH LEG

LEG PROTRUSION MUST

MEET REQUIREMENTS