PTCSL20 datasheet(3/4 Pages) VISHAY

3 / 4 page

PTCSL20 Series

www.vishay.com

Vishay BCcomponents

Revision: 04-Dec-15

Document Number: 29012

For technical questions, contact: nlr@vishay.com

THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE. THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT

ARE SUBJECT TO SPECIFIC DISCLAIMERS, SET FORTH AT www.vishay.com/doc?91000

APPLICATION SPECIFIC DATA

Negative Temperature Coefficient (NTC) thermistors are well known for temperature sensing. What is not well known, however,

is that Positive Temperature Coefficient (PTC) thermistors can be used for thermal protection. Although their operating

principles are similar, the applications are very different; whereas NTC thermistors sense and measure temperature over a

defined range, PTC thermistors switch at one particular temperature.

Just like thermostats they protect such equipment and components as motors, transformers, power transistors and thyristors

against over temperature. A PTC thermistor is less expensive than a thermostat, and its switch temperature can be more

accurately specified. It is also smaller and easier to design-in to electronic circuitry.

So how does it work? The PTC thermistor is mounted in thermal contact with the equipment to be protected, and connected

into the bridge arm of a comparator circuit, such as shown in Fig. 1. At normal temperature, the PTC thermistor resistance (Rp)

is lower than Rs (see Fig. 2), so the comparator’s output voltage VO will be low. If an equipment over temperature occurs, the

PTC thermistor will quickly heat up to its trigger or nominal reference temperature Tn, whereupon its resistance will increase to

a value much higher than Rs, causing VO to switch to a high level sufficient to activate an alarm, relay or power shutdown circuit.

APPLICATION EXAMPLES

Fig. 1 - Typical Comparator Circuit

Fig. 2 - Typical Switch Characteristic

Fig. 3 - Temperature Protection of 3-phase electric motor

PTC

thermistor



Trigger

temperature

T (°C)

p > Rs

(R1 = R2)

p < Rs

(R1 = R2)

As soon as one or more of the windings becomes too hot, the

motor is switched off.

PTCSL20 데이터시트(PDF) 3 Page - Vishay Siliconix