LPS225HB datasheet(33/47 Pages) STMICROELECTRONICS

33 / 47 page

DocID030115 Rev 2

33/47

LPS225HB

8.4

WHO_AM_I (0Fh)

Device Who am I

Address:

0Fh (R)

Description:

Contains the device Who am I address (B1h).

8.5

CTRL_REG1 (10h)

Control register 1

Address:

10h (R/W)

Reset:

00h

Description:

Control register.

[7] Reserved: this bit must be set to ‘0’ for the correct operation of the device

[6:4] ODR2, ODR1, ODR0: output data rate selection.

Default value: 000 (see Table 16)

[3] EN_LPFP: Enable low-pass filter on pressure data. Default value: 0

(0: Low-pass filter disabled; 1: Low-pass filter enabled)

[2] LPF_CFG: Low-pass configuration register. Default value: 0 (see Table 17)

[1] BDU: block data update.

Default value: 0

(0: continuous update; 1: output registers not updated until MSB and LSB have

been read)

[0] SIM: SPI Serial Interface Mode selection.

Default value: 0

(0: 4-wire interface; 1: 3-wire interface)

54321

11000

54321

ODR2

ODR1

ODR0

EN_LPFP

LPF_CFG

BDU

SIM

LPS225HB 데이터시트(PDF) 33 Page - STMicroelectronics

LPS225HB 데이터시트(HTML) 33 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47

데이터시트 다운로드

링크 URL