TDA7705 datasheet(12/42 Pages) STMICROELECTRONICS

12 / 42 page

Function description

TDA7705

12/42

Doc ID 15938 Rev 9

2.12

IO interface pins

The TDA7705 has the following IO pins:

The pins labeled GPIO0, 1, 2 and 3 (pins 43 to 40) are reserved.

The pin PLLTEST output voltage can be freely programmed via software and be used to

drive switches if needed by the application.

All the inputs are voltage-tolerant up to 3.5 V . The outputs can drive currents up to 0.5 mA

from the internal 3.3 V supply line.

2.13

Serial interface

The device is controlled with a standard I2C bus or SPI interface.

Through the serial bus the processing parameters can be modifed and the signal quality

parameters and the RDS information can be read out.

The operation of the device is handled through high level commands sent by the main car-

radio µP through the serial interface, which allow to simplify the operations carried out in the

main µP. The high level commands include among others:

●

set frequency (which allows to avoid computing the PLL divider factors);

●

start seek (the seek operation can be carried out by the TDA7705 in a completely

autonomous fashion);

●

RDS seek/search (jumps to AF and quality measurements are automatically

sequenced).

2.13.1

Serial interface choice / boot mode

The device can communicate with the main µP with two different standard serial protocols:

SPI and I2C. The configuration is chosen by setting the proper value (0V or 3.3V) at pins 35

and 39 and it is latched (e.g. made effective) when the RSTN line transitions from low to

high (when RSTN is low, the IC is in reset mode).

The voltage level forced to pins 35 and 39 must be released to start the system operation a

suitable time after the RSTN line has gone high.

The list of configurations is shown in the following table:

PLLTEST

pin 2

general purpose output

SPI_CS

pin 34

serial communication with µP

SPI_MISO

pin 35

serial communication with µP

SDA/MOSI

pin 36

serial communication with µP

SCL/CLK

pin 37

serial communication with µP

RDSINT

pin 39

serial communication with µP

RSTN

pin 45

reset pin driven by µP

TDA7705 데이터시트(PDF) 12 Page - STMicroelectronics

TDA7705 데이터시트(HTML) 12 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42

데이터시트 다운로드

링크 URL