SF2 datasheet(6/7 Pages) NAIS

6 / 7 page

263

The table below shows the state of the other contacts when the current through the welded form “a” contact is 0 V and the rated volt-

age is applied through the form “b” contact.

Contact Operation Table

No.4

No.3

No.1

No.2

Contact No.

No.1

No.2

No.3

No.4

Terminal No.

11–12

7–8

5–6

9–10

State of other contacts

1234

Welded

terminal

No.

>0.5

Note: Contact gaps are shown at the initial state.

If the contacts change state owing to loading/breaking

it is necessary to check the actual loading.

>0.5: contact gap is kept at min. 0.5 mm .020 inch

Empty cells: either closed or open

Contact No.

If the No. 3 contact welds.

Each of the two form “a” contacts (Nos. 1, 2, and

4) maintain a gap of greater than 0.5 mm .020

inch.

No.4

No.3

No.1

No.2

Non-energized

No.4

No.3

No.1

No.2

Energized (when no. 3 contact is welded)

When the form “a” contacts (nos. 1, 2, and 4) weld, the armature remains in a non-returned state and the contact gap at the single

form “b” contact is maintained at greater than 0.5 mm .020 inch. Reliable isolation is thus ensured.

Form “a” Contact Weld

If the No. 2 contact welds.

The single form “b” contact (No. 3) maintains a

gap of greater than 0.5 mm .020 inch.

No.4

No.3

No.1

No.2

Energized

No.4

No.3

No.1

No.2

Non-energized (when no. 2 contact is welded)

2) 3a1b Type

If the form “b” contact (No. 3) welds, the armature becomes non-operational, the contact gaps at the three form “a” contacts are

maintained at greater than 0.5 mm .020 inch. Reliable isolation is thus ensured

Form “b” Contact Weld

SF2 데이터시트(PDF) 6 Page - Nais(Matsushita Electric Works)

SF2 데이터시트(HTML) 6 Page - Nais(Matsushita Electric Works)

Html Pages

1 2 3 4 5 6 7

데이터시트 다운로드

링크 URL