A5975AD datasheet(32/50 Pages) STMICROELECTRONICS

32 / 50 page

Application information

A5975AD

32/50

Doc ID 018761 Rev 1

8.4

RMS current of the embedded power MOSFET

As the A5975AD embeds the high side switch, the internal power dissipation is sometimes

the bottleneck for the output current capability (refer to Section 8.3 for an estimation of the

operating temperature).

Nevertheless, as mentioned in the general description on page 1, the device can manage a

continuous output current of 2.5 A in most of the application conditions.

However, the rated maximum RMS current of the power elements is 2 A, where:

and the real duty cycle is D:

Fixing the limit of 2 A for IRMS HS, the maximum output current can be derived, as illustrated

in Figure 18.

Figure 18.

Maximum continuous output current vs. duty cycle

8.5

Short-circuit protection

In overcurrent protection mode, when the peak current reaches the current limit, the device

reduces the TON down to its minimum value (approximately 250 nsec) and the switching

frequency to approximately one third of its nominal value even when synchronized to an

external signal (see Section 5.4). In these conditions, the duty cycle is strongly reduced and,

in most applications, this is enough to limit the current to ILIM. In any event, in case of heavy

short-circuit at the output (VO = 0 V) and depending on the application conditions (VCC value

and parasitic effect of external components), the current peak could reach values higher

than ILIM.

RMS HS

LOAD

⋅

OUT

DS(on) LS

DCR

() I

LOAD

⋅

DS(on) LS

DS(on) HS

–

() I

LOAD

⋅

----------------------------------------------------------------------------------------------------

A5975AD 데이터시트(PDF) 32 Page - STMicroelectronics

A5975AD 데이터시트(HTML) 32 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50

데이터시트 다운로드

링크 URL