Supported commands

UM0285

28/32

7.2.9

Firmware version

The *ver command inquiries the evaluation kit and returns the version of the FW loaded on

the microprocessor mounted on it.

7.3

Quick Start

This section shows the basic sequence of commands to start a data communication session

and to retrieve the acceleration data from Evaluation kit.

1.

Connect the EK3LV02DL to the USB port

2.

Start the “Hyper Terminal” and configure it as described in section 7.1

3.

Inside the “Hyper Terminal” window enter the command *Zoff to enable the control of

the SPI line from the ST7-USB microcontroller

4.

Send the *debug command to get the acceleration data measured from the senor

5.

Send *stop to stop the continuos acquisition and visualization.