ST10F296E datasheet(90/346 Pages) STMICROELECTRONICS

90 / 346 page

Obsolete

Product(s)

- Obsolete

Product(s)

The bootstrap loader

ST10F296E

90/346

6.7

Selective boot mode

Selective boot mode is a sub-case of alternate boot mode.

The following additional check is made when no signature of the alternate boot mode

signature check is correct:

Address 00’1FFCh is read again.

●

If a value 0000h or FFFFh is obtained, a jump is performed to the standard bootstrap

loader.

●

If the value obtained is not 0000h or FFFFh:

–

High byte bits are disregarded

–

Low byte bits select which communication channel is enabled (see Table 44).

●

0xXX03 configures the selective bootstrap loader to poll for RxD0 and CAN1_RxD.

●

0xXX01 configures the selective bootstrap loader to poll RxD0 only (no bootloading via

CAN).

●

0xXX02 configures the selective bootstrap loader to poll CAN1_RxD only (no

bootloading via UART).

●

other values will let the ST10F296E executing an endless loop into the Test-Flash.

Table 44.

Selective boot mode configurations

Bit

Function

UART selection

0: UART not watched for a start condition

1: UART is watched for a start condition

CAN1 selection

0: CAN1 not watched for a start condition

1: CAN1 is watched for a start condition

2-7

Reserved

Must be programmed to 0 for upward compatibility

Obsolete

Product(s)

- Obsolete

Product(s)

ST10F296E 데이터시트(PDF) 90 Page - STMicroelectronics

ST10F296E 데이터시트(HTML) 90 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL