STM32F769II datasheet(111/255 Pages) STMICROELECTRONICS

111 / 255 page

DocID029041 Rev 4

111/255

STM32F765xx STM32F767xx STM32F768Ax STM32F769xx

Electrical characteristics

224

Electrical characteristics

5.1

Parameter conditions

Unless otherwise specified, all voltages are referenced to VSS.

5.1.1

Minimum and maximum values

Unless otherwise specified the minimum and maximum values are guaranteed in the worst

conditions of ambient temperature, supply voltage and frequencies by tests in production on

100% of the devices with an ambient temperature at TA = 25 °C and TA = TAmax (given by

the selected temperature range).

Data based on characterization results, design simulation and/or technology characteristics

are indicated in the table footnotes. Based on characterization, the minimum and maximum

values refer to sample tests and represent the mean value plus or minus three times the

standard deviation (mean±3σ).

5.1.2

Typical values

Unless otherwise specified, typical data are based on TA = 25 °C, VDD = 3.3 V (for the

1.7 V

≤ VDD ≤ 3.6 V voltage range). They are given only as design guidelines and are not

tested.

Typical ADC accuracy values are determined by characterization of a batch of samples from

a standard diffusion lot over the full temperature range, where 95% of the devices have an

error less than or equal to the value indicated (mean±2σ).

5.1.3

Typical curves

Unless otherwise specified, all typical curves are given only as design guidelines and are

not tested.

5.1.4

Loading capacitor

The loading conditions used for pin parameter measurement are shown in Figure 22.

5.1.5

Pin input voltage

The input voltage measurement on a pin of the device is described in Figure 23.

Figure 22. Pin loading conditions

Figure 23. Pin input voltage

STM32F769II 데이터시트(PDF) 111 Page - STMicroelectronics