P3602ACMC datasheet(187/212 Pages) TECCOR

187 / 212 page

TeleLink Fuse Soldering

5 - 25

http://www.teccor.com

SIDACtor® Data Book and Design Guide

+1 972-580-7777

TeleLink Fuse Soldering

For wave soldering a TeleLink fuse, the following temperature and time are recommended:

• Reservoir temperature of 260 °C (500 °F)

• Time in reservoir — three seconds maximum

For infrared, the following temperature and time are recommended:

• Temperature of 240 °C (464 °F)

• Time — 30 seconds maximum

Hand soldering is not recommended for this fuse because excessive heat can affect the

fuse performance. Hand soldering should be used only for rework and low volume samples.

Note the following recommendations for hand soldering:

• Maximum tip temperature of 240 °C (464 °F)

• Minimize the soldering time at temperature to achieve the solder joint. Measure the fuse

resistance before and after soldering. Any fuse that shifts more than ±3% should be

replaced. An increase in resistance above this amount increases the possibility of a

surge failure, and a decrease in resistance may cause low overloads to exceed the

maximum opening times.

• Inspect the solder joint to ensure an adequate solder fillet has been produced without

any cracks or visible defects.

P3602ACMC 데이터시트(PDF) 187 Page - Teccor Electronics