N76E003 datasheet(7/267 Pages) ETC2

7 / 267 page

N76E003 Datasheet

Jun 26, 2017

Page 7 of 267

Rev. 1.02

– One 16-bit Timer 2 with three-channel input capture module and 9 input pin can be selected.

– One 16-bit auto-reload Timer 3, which can be the baud rate clock source of UARTs.

– One 16-bit PWM counter interrupt for timer.

– One programmable Watchdog Timer (WDT) clocked by dedicated 10 kHz internal source.

– One dedicated Self Wake-up Timer (WKT) for self-timed wake-up for power reduced modes.

– Two full-duplex UART ports with frame error detection and automatic address recognition. TXD

and RXD pins of UART0 exchangeable via software.

– One SPI port with master and slave modes, up to 8 Mbps when system clock is 16 MHz.

– One I

C bus with master and slave modes, up to 400 kbps data rate.

– Three pairs, six channels of pulse width modulator (PWM) output, 10 output pins can be

selected., up to 16-bit resolution, with different modes and Fault Brake function for motor

control.

– Eight channels of pin interrupt, shared for all I/O ports, with variable configuration of edge/level

detection.

– One 12-bit ADC, up to 500 ksps converting rate, hardware triggered and conversion result

compare facilitating motor control.

 Power management:

– Two power reduced modes: Idle and Power-down mode.

 Power monitor:

– Brown-out detection (BOD) with low power mode available, 4-level selection, interrupt or reset

options.

– Power-on reset (POR).

 Strong ESD and EFT immunity.

 Development Tools:

– Nuvoton On-Chip-Debugger (OCD) with KEIL

development environment.

– Nuvoton In-Circuit-Programmer (ICP).

– Nuvoton In-System-Programming (ISP) via UART.

N76E003 데이터시트(PDF) 7 Page - List of Unclassifed Manufacturers