PI5C3303 datasheet(2/5 Pages) PERICOM

2 / 5 page

PS8367D

10/14/04

PI5C3303

SOTiny™ 2:1 Mux/DeMux Bus Switch

Storage Temperature ..........................................................–65°C to +150°C

Ambient Temperature with Power Applied .........................–40°C to +85°C

Supply Voltage to Ground Potential......................................–0.5V to +7.0V

DC Input Voltage ..................................................................–0.5V to +7.0V

DC Output Current.............................................................................120mA

Power Dissipation .................................................................................0.5W

Note: Stresses greater than those listed under MAXI-

MUM RATINGS may cause permanent damage to

the device. This is a stress rating only and functional

operation of the device at these or any other conditions

above those indicated in the operational sections of this

specification is not implied. Exposure to absolute max-

imum rating conditions for extended periods may affect

reliability.

Maximum Ratings

(Above which the useful life may be impaired. For user guidelines, not tested.)

DC Electrical Characteristics (Over the Operating Range, TA = –40°C to +85°C, VCC = 5V ± 10%)

Parameters

Description

Test Conditions(1)

Min.

Typ.(2) Max. Units

VIH

Input HIGH Voltage

Guaranteed Logic HIGH Level

2.0

VIL

Input LOW Voltage

Guaranteed Logic LOW Level

–0.5

0.8

IIH

Input HIGH Current

VCC = Max., VIN = VCC

±1

µA

IIL

Input LOW Current

VCC = Max., VIN = GND

±1

IOZ

High Impedence Output Current VCC = Max., VOUT = 0V or VCC

±1

RON

Switch On-Resistance(3)

VCC = 4V, VIN = 2.4V,

ION = -15mA

Ω

VCC = 4.5V, VIN = 0V,

ION = 30mA or 64mA

VCC = 4.5V, VIN = 2.4V, ION = -15mA

Capacitance (TA = 25°C, f = 1 MHz)

Parameters(4)

Description

Test Conditions

Type(4)

Units

CIN

Input Capacitance

VIN = 0V

COFF

A/B Capacitance, Switch Off

CON

A/B Capacitance, Switch On

Notes:

1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.

2. Typical values are at VCC = 5.0V, TA = 25°C ambient and maximum loading.

3. Measured by the voltage drop between A and B pin at indicated current through the switch. On-Resistance is determined by the lower of the

voltages on the two (A, B) pins.

4. This parameter is determined by device characterization but is not production tested.

PI5C3303 데이터시트(PDF) 2 Page - Pericom Semiconductor Corporation

PI5C3303 데이터시트(HTML) 2 Page - Pericom Semiconductor Corporation

Html Pages

1 2 3 4 5

데이터시트 다운로드

링크 URL