TL32 datasheet(28/31 Pages) ETC

28 / 31 page

hperry

5/4/01

Rqmt #

Description

Method

Test (if applicable)

The simulator will have three types of output. It will:

1. send information to the controller specifying altitude, velocity, and whether

there is fuel remaining;

Test

The simulator will have three types of output. It will:

2. call a graphics package (provided) that will display a representation of the

lander as it descends. The simulator must determine the condition of the vehicle

using one of four conditions defined in the Graphics Package Interface section

(see "vehicle-condition" variable);

Test

The simulator will have three types of output. It will:

3. write altitude, velocity, thrust and fuel remaining information to a telemetry

file using the same format as the simulation in PS8 (plus a fuel remaining

column), and write an error message to the telemetry file if the graphics package

returns an error condition.

Test

The simulation will end when the vehicle reaches 0 meters of altitude or goes

above its initial altitude.

Test

(see rqmt 3)

Simulation code will interface to the provided graphics package

Test

Demo

The serial interface should be used to continually send data back and forth

between the simulation and the controller.

Test

Data sent from the simulation to the controller shall correspond to the provided

interface specification

Test

Data sent from the controller to the simulation shall correspond to the provided

interface specification

Test

Section 4 - Requirements Traceability (continued)

TL32 데이터시트(PDF) 28 Page - List of Unclassifed Manufacturers