24

TPA3136D2, TPA3136AD2

SLOS938D – MAY 2016 – REVISED MARCH 2017

www.ti.com

Product Folder Links: TPA3136D2 TPA3136AD2

Submit Documentation Feedback

Copyright © 2016–2017, Texas Instruments Incorporated

12 Layout

12.1 Layout Guidelines

The TPA3136D2/TPA3136AD2 device can be used with a small, inexpensive ferrite bead output filter for most

applications. However, since the Class-D switching edges are fast, it is necessary to take care when planning the

layout of the printed circuit board. The following suggestions will help to meet EMC requirements.

•

Decoupling capacitors—The high-frequency decoupling capacitors should be placed as close to the PVCC

and AVCC pins as possible. Large (100-µF or greater) bulk power supply decoupling capacitors should be

placed near the TPA3136D2/TPA3136AD2 device on the PVCC supplies. Local, high-frequency bypass

capacitors should be placed as close to the PVCC pins as possible. These caps can be connected to the

thermal pad directly for an excellent ground connection. Consider adding a small, good quality low ESR

ceramic capacitor between 220 pF and 1000 pF and a larger mid-frequency cap of value between 0.1 μF and

1 μF also of good quality to the PVCC connections at each end of the chip.

•

Keep the current loop from each of the outputs through the ferrite bead and the small filter cap and back to

GND as small and tight as possible. The size of this current loop determines its effectiveness as an antenna.

•

Grounding—The AVCC (pin 14) decoupling capacitor should be connected to ground (GND). The PVCC

decoupling capacitors should connect to GND. Analog ground and power ground should be connected at the

thermal

pad,

which

should

be

used

as

a

central

ground

connection

or

star

ground

for

the

TPA3136D2/TPA3136AD2.

•

Output filter—The ferrite EMI filter (Figure 20) should be placed as close to the output pins as possible for the

best EMI performance. The capacitors used in the ferrite should be grounded to power ground.

•

Thermal Pad—The thermal pad must be soldered to the PCB for proper thermal performance and optimal

reliability. The dimensions of the thermal pad and thermal land should be 6.46 mm × 2.35 mm. Six rows of

solid vias (three vias per row, 0.3302 mm or 13 mils diameter) should be equally spaced underneath the

thermal land. The vias should connect to a solid copper plane, either on an internal layer or on the bottom

layer of the PCB. The vias must be solid vias, not thermal relief or webbed vias. See the TI Application

Report SLMA002 for more information about using the TSSOP thermal pad. For recommended PCB

footprints, see figures at the end of this data sheet.

For an example layout, see the TPA3136D2 Evaluation Module (TPA3136D2EVM) User Manual. Both the EVM

user manual and the thermal pad application report are available on the TI Web site at http://www.ti.com.