www.irf.com

3

ATR28XXT Series

T

Notes to Specifications

Specifications

1.

Tested at each output.

2.

Parameter guaranteed byline and load regulation tests.

3.

Although operation with no load is permissible, light loading on the main (+5 volt) output may cause the output voltage of the

auxiliary outputs (

±12 volt or ±15 volt) to drop out of regulation. It is therefore recommended that at least 100mA or 20 percent of

the output power, whichever is greater, be taken from the main (+5 volt) output.

4.

Total combined output power –30 watts.

5.

Bandwidth guaranteed by design. Tested for 20KHz to 2MHz.

6.

An overload is that condition with a load in excess of the rated load but less than that necessary to trigger the overload protection

circuit and is the condition of maximum power dissipation.

7.

Load step transition time between 2 and 10 microseconds.

8.

Recovery time is measured from the initiation of the transient to where V

load.

9.

Input step transition time between 2 to 10 microseconds.

10. Parameter shall be tested as part of design characterization and after design or process changes. Thereafter parameters shall be

guaranteed to the limits specified in the table.

11. Turn on delay time measurement is for either a step application of power at the input or the removal of a ground signal from the

inhibit pin (pin 8) while power is applied to the input.

ABSOLUTE MAXIMUM RATINGS

Input Voltage

-0.5V to 50VDC

Power Output

Internally limited, 37.5W typical

Soldering

300

°C for 10 seconds

Operating

-55

°C to +135°C case

Storage

-65

°C to +135°C

ATR2812T

ATR2815T

Test

Symbol

Conditions

-55

°C ≤ TC ≤ +125°C,

unless otherwise specified

Min

Max

Min

Max

Units

STATIC CHARACTERISTICS

Output Response to

Input step 16 from/to 40 VDC

±1500

±1500

mV pk

Input step 16 from/to 40 VDC

10

10

ms

1000

1000

mV pk

25

25

ms

25

25

ms

Device weight

65

65

g