AD7680ARMZ datasheet(18/25 Pages) AD

18 / 25 page

AD7680

Rev. A | Page 17 of 24

SERIAL INTERFACE

Figure 20 shows the detailed timing diagram for serial

interfacing to the AD7680. The serial clock provides the

conversion clock and also controls the transfer of information

from the AD7680 during conversion.

The CS signal initiates the data transfer and conversion process.

The falling edge of CS puts the track-and-hold into hold mode,

takes the bus out of three-state, and samples the analog input.

The conversion is also initiated at this point and requires at least

20 SCLK cycles to complete. Once 17 SCLK falling edges have

elapsed, the track-and-hold goes back into track mode on the

next SCLK rising edge. Figure 20 shows a 24 SCLK transfer that

allows a 100 kSPS throughput rate. On the 24th SCLK falling

edge, the SDATA line goes back into three-state. If the rising

edge of CS occurs before 24 SCLKs have elapsed, the conversion

terminates and the SDATA line goes back into three-state;

otherwise SDATA returns to three-state on the 24th SCLK

falling edge as shown in Figure 20.

A minimum of 20 serial clock cycles are required to perform

the conversion process and to access data from the AD7680.

CS going low provides the first leading zero to be read in by the

microcontroller or DSP. The remaining data is then clocked out

by subsequent SCLK falling edges beginning with the second

leading zero; thus the first falling clock edge on the serial clock

has the first leading zero provided and also clocks out the

second leading zero. If a 24 SCLK transfer is used as in Figure 20,

the data transfer consists of four leading zeros followed by the

16 bits of data, followed by four trailing zeros. The final bit

(fourth trailing zero) in the data transfer is valid on the 24th

falling edge, having been clocked out on the previous (23rd)

falling edge. If a 20 SCLK transfer is used as shown in Figure 21,

the data output stream consists of only four leading zeros

followed by 16 bits of data with the final bit valid on the 20th

SCLK falling edge. A 20 SCLK transfer allows for a shorter cycle

time and therefore a faster throughput rate is achieved.

tQUIET

tCONVERT

4 LEADING ZEROS

3-STATE

ZERO

DB15

DB1

DB0

ZERO

SCLK

1234

SDATA

4 TRAILING ZEROS

Figure 20. AD7680 Serial Interface Timing Diagram—24 SCLK Transfer

tQUIET

tCONVERT

ZERO

DB15

DB1

DB0

SCLK

SDATA

4 LEADING ZEROS

3-STATE

Figure 21. AD7680 Serial Interface Timing Diagram—20 SCLK Transfer

AD7680ARMZ 데이터시트(PDF) 18 Page - Analog Devices

AD7680ARMZ 데이터시트(HTML) 18 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25

데이터시트 다운로드

링크 URL