PM9604/5AP

sames

5/14

6.

Jumper Configurations

The jumper configufations required for the two devices types are shown below:

JUMPER POSITION

SA9604A

SA9605A

NOTES

JP1

1 - 2

Insert

Insert

JP2

1 - 2

Insert

Insert

Note 1

JP3

1 - 2

Insert

Insert

JP4

1 - 2

Remove

Insert (FOUT1)

2 - 3

Remove

Insert (FOUT2)

Note 2

3 - 4

Insert (SCK)

Remove

JP5

1 - 2

Remove

Insert (PGM1=1)

Note 3

2 - 3

Insert (CS)

Remove (PGM1=0)

JP6

1 - 2

Remove

Insert (PGM0=1)

Note 3

2 - 3

Insert (DI)

Remove (PGM0=0)

JP7

1 - 2

Remove

Insert

Note 1:

The removal of the link on the current sensor input must only be

performed during calibration.

Note 2:

Only one of the two output pulse signals on the SA9605A may be

selected at any one time using this module. In a users application both

of these signals may be used.

Note 3:

The SA9605A I.C. has on-board pull-down resistors, pull-up connection

to VDD is, therefore, the only connection which must be catered for.