| 전자부품 데이터시트 검색엔진 |
|
USB375X 데이터시트(PDF) 27 Page - Microchip Technology |
|
|
|||||||||||||||||||||||||||||
USB375X 데이터시트(HTML) 27 Page - Microchip Technology |
|
27 / 31 page ![]() 2011 - 2014 Microchip Technology Inc. DS00001824A-page 27 USB375x APPENDIX A: DATA SHEET REVISION HISTORY TABLE A-1: REVISION HISTORY Revision Section/Figure/Entry Correction DS00001824A (09-22-14) Replaces previous SMSC version Rev. 1.1 (02-12-13); document is converted to Microchip template Product Identification Sys- tem on page 29 Reel size is changed from 4000 to 5000; tempera- ture range designator and explanation removed Package Information on page 25 The following diagrams removed: Reel Dimen- sions, Tape Sections and Package Marking. Section 2.2, "Pin Definitions" Description for pins 12 and 13 modified. All Updated Battery Charging references to revision 1.2 of the specification. Section 1.0, "Introduction," on page 4 • Added note: “The device’s Data Contact Detect Timeout parameter does not conform to the USB Battery Charging Specification. How- ever, this will not affect other factors in charger detection. Refer to Table 3-2, “Electrical Speci- fications,” on page 7 for additional informa- tion.” • Added cross-references to new note on all mentions of the Battery Charging Specification in this section. Table 3-2, “Electrical Specifi- cations,” on page 7 • Updated VBUS Over Voltage Lockout values to be specific for the USB3750 and USB3751 • Updated Data Contact Detect Timeout values and added note: The device’s Data Contact Detect Timeout parameter does not conform to the USB Battery Charging Specification. How- ever, this will not affect other factors in charger detection.” Rev. 1.1 (02-12-13) All Misc. typos, etc. Section 4.4.1, "I2C Interface," on page 18 Added additional paragraph: “The USB375x-1 requires I2C communications in order for the default USB path to be enabled. By default, the 100mA current limit is enabled. Only devices that draw <100mA will be enabled through the path as part of dead battery provision support. In order to bypass this limit, bits 0 (EnableOVP Switch) and 2 (OverideVBUS) in Register 1 (Configuration Register) need to be set via I2C.” Rev. 1.0 (09-02-11) Initial Release |
|
링크 URL |
| ALLDATASHEET 가 귀하에 도움이 되셨나요? [ DONATE ] |
Alldatasheet는? | 광고문의 | 운영자에게 연락하기 | 개인정보취급방침 | 링크 투 데이터시트 | 링크교환 | 제조사별 검색 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |