EPCQ32 datasheet(39/48 Pages) INTEL

39 / 48 page

The device initiates a self-timed erase sector cycle immediately after the nCS signal is

driven high. For details about the self-timed erase sector cycle time, refer to tES in the

related information below. You must account for this amount of delay before another

page of memory is written. Alternatively, you can check the write in progress bit in the

status register by executing the read status operation while the self-timed erase cycle

is in progress. The write in progress bit is set to 1 during the self-timed erase cycle

and 0 when it is complete. The write enable latch bit in the status register is set to 0

before the self-timed erase cycle is complete.

Related Information

Write Operation Timing on page 40

The Write Operation Parameters provides more information about tWS, tES and tWB.

1.7.14. Erase Subsector Operation

The erase subsector operation allows you to erase a certain subsector in the EPCQ

device by setting all the bits inside the subsector to 1 or 0xFF. This operation is useful

if you want to access the unused subsectors as a general purpose memory in your

applications. You must execute the write enable operation before the erase subsector

operation.

When you execute the erase subsector operation, you must first shift in the erase

subsector operation code, followed by the 3-byte addressing mode (A[23..0]) or the

4-byte addressing mode (A[31..0]) of the chosen subsector on the DATA0 pin. The

3-byte addressing mode or the 4-byte addressing mode for the erase subsector

operation can be any address inside the specified subsector. For details about the

subsector address range, refer to the related information below. Drive the nCS signal

high after the eighth bit of the erase subsector operation code has been latched in.

Figure 21.

Erase Subsector Operation Timing Diagram

To access the entire EPCQ256 or EPCQ512/A memory, use 4-byte addressing mode. In the 4-byte addressing

mode, the address width is 32-bit address.

DATA0

Operation Code (20h)

24-Bit Address

nCS

DCLK

28 29 30 31

23 22

MSB

The device initiates a self-timed erase subsector cycle immediately after the nCS

signal is driven high. For details about the self-timed erase subsector cycle time, refer

to related the information below. You must account for this amount of delay before

another page of memory is written. Alternatively, you can check the write in progress

bit in the status register by executing the read status operation while the self-timed

erase cycle is in progress. The write in progress bit is set to 1 during the self-timed

erase cycle and 0 when it is complete. The write enable latch bit in the status register

is set to 0 before the self-timed erase cycle is complete.

Related Information

•

Write Operation Timing on page 40

1. Quad-Serial Configuration (EPCQ) Devices Datasheet

CF52012 | 2018.06.01

Quad-Serial Configuration (EPCQ) Devices Datasheet

EPCQ32 데이터시트(PDF) 39 Page - Intel Corporation

EPCQ32 데이터시트(HTML) 39 Page - Intel Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48

데이터시트 다운로드

링크 URL