PIC12F635ESLASHP datasheet(71/196 Pages) MICROCHIP

71 / 196 page

Preliminary

DS41232B-page 69

PIC12F635/PIC16F636/639

7.7

Comparator Response Time

Response time is the minimum time, after selecting a

new reference voltage or input source, before the

comparator output is ensured to have a valid level. If

the internal reference is changed, the maximum delay

of the internal voltage reference must be considered

when using the comparator outputs. Otherwise, the

maximum delay of the comparators should be used

(Table 15-7).

7.8

Operation During Sleep

The comparators and voltage reference, if enabled

before entering Sleep mode, remain active during

Sleep. This results in higher Sleep currents than shown

in the power-down specifications. The additional

current consumed by the comparator and the voltage

reference is shown separately in the specifications. To

minimize power consumption while in Sleep mode, turn

off the comparator, CM<2:0> = 111 and voltage

reference, VRCON<7> = 0.

While the comparator is enabled during Sleep, an

interrupt will wake-up the device. If the GIE bit

(INTCON<7>) is set, the device will jump to the

interrupt vector (0004h) and if clear, continues

execution with the next instruction. If the device wakes

up from Sleep, the contents of the CMCON0, CMCON1

and VRCON registers are not affected.

7.9

Effects of a Reset

A device Reset forces the CMCON0, CMCON1 and

VRCON registers to their Reset states. This forces the

comparator module to be in the Comparator Reset

mode, CM<2:0> = 000 and the voltage reference to its

OFF state. Thus, all potential inputs are analog inputs

with the comparator and voltage reference disabled to

consume the smallest current possible.

VRCON – VOLTAGE REFERENCE CONTROL REGISTER (ADDRESS: 99h)

R/W-0

U-0

R/W-0

VREN

—VRR

—

VR3

VR2

VR1

VR0

bit 7

bit 0

bit 7

VREN: CVREF Enable bit

= CVREF circuit powered on

= CVREF circuit powered down, no IDD drain and CVREF = VSS

bit 6

Unimplemented: Read as ‘0’

bit 5

VRR: CVREF Range Selection bit

= Low range

= High range

bit 4

Unimplemented: Read as ‘0’

bit 3-0

VR<3:0>: CVREF Value Selection bits 0

≤ VR<3:0> ≤ 15

When VRR = 1:

CVREF = (VR<3:0>/24) * VDD

When VRR = 0:

CVREF = VDD/4 + (VR<3:0>/32) * VDD

Legend:

R = Readable bit

W = Writable bit

U = Unimplemented bit, read as ‘0’

- n = Value at POR

‘1’ = Bit is set

‘0’ = Bit is cleared

x = Bit is unknown

PIC12F635E/P 데이터시트(PDF) 71 Page - Microchip Technology

PIC12F635E/P 데이터시트(HTML) 71 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL