| 전자부품 데이터시트 검색엔진 |
|
TDC-GPX2 데이터시트(PDF) 54 Page - ams AG |
|
|
|||||||||||||||||||||||||||||
TDC-GPX2 데이터시트(HTML) 54 Page - ams AG |
|
54 / 77 page ![]() Page 54 ams Datasheet Document Feedback [v1-03] 2017-Dec-18 TDC-GPX2 − Detailed Description FIFOs for Adapting Peak and Average Conversion Rate Each channel of GPX2 has a First-In-First-Out data buffer (FIFO). Generally, GPX2 is capable of measuring the incoming stops faster than the length of an output sequence. The FIFO is capable of storing up to data of 16 stop events until the data are read out. Up to a certain degree, the FIFO prevents rejection of stop events for a short time when the input stop event rate is higher than the read-out rate. But when the input data rate is constantly higher than the read-out rate, then the FIFO gets full and stop events are rejected. After a full FIFO was read out and empty space is available for stop measurement further two stops are needed to restart the FIFO (tFIFO_RESTART). The maximum FIFO depth is 16, 8 or 4 stages, depending on the HIGH_RESOLUTION configuration (off, 2x, 4x). The following figures illustrate the typical dependencies between stop event rate and the read out rate. They are applicable for both SPI and LVDS readout. The INTERRUPT pin indicates that the result is available for read-out through the SPI interface. For SPI a continuous readout is assumed as long as the interrupt is on low level. For LVDS output the FRAME indicates the beginning of data output at SDO line. The interrupt goes back to HIGH when all FIFOs are empty even if output is LVDS. In the figures FIFO_DEPTH = 4 is assumed. The FIFO LEVEL indicates the stop event buffered in the FIFO. A stop event will increase FIFO LEVEL by one, reading out will decrease the FIFO LEVEL. Figure 57: Input Stop Event Rate is Lower than the Readout Rate • Enough time for complete readout of first stop before the next stop event arises • Interrupt goes back to high because the FIFO is empty after read-out • In this example, no stop events are rejected. All stops are measured and read out #1 #1 INTERRUPT FRAME STOP SDO FIFO LEVEL 0 1 #3 0 #2 #2 1 0 #3 1 0 Stop#1 Stop#2 Stop #3 |
|
링크 URL |
| ALLDATASHEET 가 귀하에 도움이 되셨나요? [ DONATE ] |
Alldatasheet는? | 광고문의 | 운영자에게 연락하기 | 개인정보취급방침 | 링크 투 데이터시트 | 링크교환 | 제조사별 검색 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |