Clock recovery system

DPO Models

Requires Option ST6G or Option MTH

MSO Models

Standard

Clock recovery phase locked loop

bandwidth

Fixed at FBaud/1600

Clock recovery jitter (RMS)

Minimum signal amplitude needed

for clock recovery

Tracking/Acquisition range

±2% of requested baud

Clock recovery frequency range

1.5 MBaud to 3.125 GBaud. Recovered clock and regenerated data available for use with a BERT.

Serial pattern trigger

DPO Models

Requires Option ST6G

MSO Models

Standard

NRZ-Encoded Data

Up to 64 bit serial word recognizer, bits specified in binary (high, low, don't care) or hex format

Trigger on NRZ-encoded data up to 1.25 GBaud

8b/10b-Encoded Data

Trigger on 8b/10b-encoded data at the following rates: 1.25 to 1.65, 2.1 to 3.2, 3.8 to 5.1, and 5.4 to 6.25 GBaud.

Pattern length up to 40 bits (1 to 4 valid 10-bit characters)

Alignment character is K28.5 (either disparity)

Communications-related triggers

Support for AMI, HDB3, BnZS, CMI, MLT3, and NRZ encoded communications signals. Select among isolated positive or negative

one, zero pulse form, or eye patterns as applicable to the standard.

DPO Models

Requires Option MTH

MSO Models

Standard

USB: low-speed, full-speed

CAN: 1 Mb/s

LIN: 100 kb/s

MIL-STD-1553B: 2 Mb/s

Logic pattern trigger (MSO

Models)

Threshold range

P6780: –2 to +4.5 V

P6717A/P6750: –1.5 to +4 V

Threshold accuracy

±100 mV + 3% of threshold setting

Enhanced triggering

Enhanced triggering corrects the difference in timing between the trigger path and the acquired data path (supports all Pinpoint

trigger types on both A- and B-Events except pattern trigger); Default On (user-selectable); Not available in FastAcq mode.

Line trigger

Trigger on power line signal. Level fixed at 0 V.

Datasheet

24 www.tek.com