TDSUSBF datasheet(10/46 Pages) TEKTRONIX

10 / 46 page

PCI Express® Transmitter Compliance and Debug (Option PCE3) – Analyze the

performance of your PCI Express® Rev 1.0, 2.0, or 3.0 (draft spec) design with

comprehensive test support. Using DPOJET, Option PCE3 enables tests that conform to

PCI-SIG standards.

NRZ and PAM4 measurements-The throughput of Datacom networks continues to

increase. Tek's DPO73304DX supports up to 10GBASE KRn data rates. The powerful

combination of the DPO70000, DPOJET Jitter and Noise Analysis, and the SDLA Serial

Data Link Analysis tool performs accurate de-embedding and eye diagram analysis for

Datacom standards.

For more information on PAM4 testing, please refer to the DPO70000SX

datasheet and related PAM4 documents.

Ethernet Compliance Test Solution (Option ET3) – Receive full PHY layer support for

Ethernet variants 10BASE-T, 100BASE-TX, and 1000BASE-T with the comprehensive,

integrated Tektronix® Ethernet tool set. Analog verification, automated compliance

software, and device characterization solutions are all included.

C-PHY uses a unique mechanism for clock recovery. C-PHY 1.0 implements a custom

clock recovery algorithm referred to as triggered eye. In this model, the first zero crossing

of the four differential signals is used as a trigger point for clock recovery and rendering

the eye diagram. The eye mask is optimally placed for maximum eye opening where the

eye height is measured. Because of the triggered eye mechanism, all the jitter at the

trigger point (zero crossing) is swallowed and reflected on the other side. Jitter and eye

diagram rendering performed over the entire record length helps designers better

characterize devices by displaying anomalies of the device over an extended period. The

software allows you to run the eye diagram analysis for 3M UI and overnight runs for a

detailed characterization.

Datasheet

10 www.tek.com

TDSUSBF 데이터시트(PDF) 10 Page - TEKTRONIX, INC.