ARA-R404M-00B datasheet(12/43 Pages) U-BLOX

12 / 43 page

SARA-R4 series - Data sheet

UBX-16024152 - R18

Interfaces

Page 12 of 43

2.3.2 Module power-off

SARA-R4 series can be properly switched off, with storage of the current parameter settings and a

clean network detach, in one of these ways:



AT+CPWROFF command (see the SARA-R4 series AT commands manual [1])



Low pulse on the PWR_ON pin for a valid time period (see section 4.2.8)

An abrupt shutdown occurs on SARA-R4 series modules, without storage of the current parameter

settings and without a clean network detach, when:



the VCC supply drops below the extended operating range minimum limit



a low level is applied on the RESET_N pin, which is normally set high by an internal pull-up, for a

valid time period (see section 4.2.9). RESET_N line has to be driven by open drain, open collector or

contact switch.

2.3.3 Module reset

SARA-R4 series modules can be reset (re-booted) by:



AT+CFUN command (see the SARA-R4 series AT commands manual [1]). This causes an “internal”

or “software” reset of the module. The current parameter settings are saved in the module’s non-

volatile memory and a clean network detach is performed.

2.4 SIM

2.4.1 SIM interface

A SIM card interface is provided on VSIM, SIM_IO, SIM_CLK, SIM_RST pins: the high-speed SIM/ME

interface is implemented as well as the automatic detection of the required SIM supporting voltage.

Both 1.8 V and 3 V SIM types are supported (1.8 V and 3 V). Activation and deactivation with an

automatic voltage switch from 1.8 V to 3 V is implemented according to the ISO-IEC 7816-3

specifications. The SIM driver supports the PPS procedure for baud-rate selection, according to the

values proposed by the SIM card/chip.

2.4.2 SIM detection

The GPIO5 pin of SARA-R4 series modules is a 1.8 V digital input which can be configured as an

external interrupt to detect the SIM card presence, as intended to be properly connected to the

mechanical switch of an external SIM card holder. For more details, see the SARA-R4 series system

integration manual [2] and the SARA-R4 series AT commands manual [1].

2.5 Serial communication

The SARA-R4 series provides the following serial communication interfaces:



UART interface: asynchronous serial interface available for the communication with a DTE host

application processor (AT commands, data communication, FW update by means of FOAT)



USB interface: High-Speed USB 2.0 compliant interface available for communications with a USB

host application processor (AT commands, data communication, FW update by means of the

FOAT feature), for FW update by means of the u-blox tool and for diagnostics



SPI interface: Serial Peripheral Interface available for communications with an external compatible

device



SDIO interface: Secure Digital Input Output interface available for communications with a

compatible device



DDC interface: I2C bus compatible interface available for communications with external I2C devices

ARA-R404M-00B 데이터시트(PDF) 12 Page - u-blox AG

ARA-R404M-00B 데이터시트(HTML) 12 Page - u-blox AG

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43

데이터시트 다운로드

링크 URL