STM1061 datasheet(6/21 Pages) STMICROELECTRONICS

6 / 21 page

STM1061

6/21

PIN DESCRIPTIONS

See Figure 2., page 4 and Table 1., page 4 for a

brief overview of the signals connected to this de-

vice.

OUT (Open Drain). This is the Open Drain Out-

put. It goes low when VCC drops below VTH–, and

remains low as long as VCC is below VTH– +

VHYST.

VCC. This is the Supply voltage and input for the

Voltage Detector.

VSS. Ground, VSS, is the reference for the power

supply. It must be connected to the system

ground.

Table 2. Pin Functions

OPERATION

Output

The STM1061 Voltage Detector monitors system

voltages from 1.6V to 5V in 100mV increments.

The detector is designed to ignore fast transients

on VCC and has a voltage hysteresis (VHYST). The

STM1061 asserts an output signal (OUT) whenev-

er VCC goes below the Voltage Detect Threshold

(VTH–). The output signal (OUT) stays asserted

until VCC goes above the Voltage Detect Release

(VTH+). Output voltage (VOUT) is guaranteed valid

down to VCC =0.7V at 25°C.

The STM1061has an open drain active-low output

which will sink current when output is asserted.

Connect a pull-up resistor from OUT to any supply

voltage up to 6V (see Figure 6., page 5). Select a

resistor value large enough to register a logic low,

and small enough to register a logic high while all

of the input current and leakage paths connected

to the reset output line are being supplied. A 10k

pull-up is sufficient in most applications.

The advantages of open drain output is the ability

to connect more open drain outputs in parallel

(wired OR connections) as well as connect the

output to a power supply voltage different from

VCC.

Negative-Going VCC Transients and

Undershoot

The STM1061 device is relatively immune to neg-

ative-going VCC transients (glitches). The graph

(see Figure 11., page 9) indicates the maximum

pulse width a negative VCC transient can have

without causing a reset pulse. As the magnitude of

the transient increases (further below the thresh-

old), the maximum allowable pulse width decreas-

es. Any combination of duration and overdrive

which lies under the curve will NOT generate a re-

set signal.

A 0.1µF bypass capacitor mounted as close as

possible to the VCC pin provides additional tran-

sient immunity.

Name

Function

SOT23-3

SOT323-3 (SC70-3)

OUT

Active-Low Open Drain Output

VCC

Supply Voltage

VSS

Ground

STM1061 데이터시트(PDF) 6 Page - STMicroelectronics

STM1061 데이터시트(HTML) 6 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21

데이터시트 다운로드

링크 URL