ADRV9002BBCZ datasheet(26/92 Pages) AD

26 / 92 page

Data Sheet

ADRV9002

TYPICAL PERFORMANCE CHARACTERISTICS

analog.com

Rev. 0 | 26 of 92

The ADRV9002 supports a signal bandwidth from 12 kHz to 40 MHz. The bandwidth of 1 MHz is the boundary to distinguish between

narrow-band and wideband profiles. If the signal bandwidth is less than 1 MHz, it is considered a narrow-band profile. Otherwise, it is

considered a wideband profile. The performance of the ADRV9002 is measured for both wideband and narrow-band profiles.

WIDEBAND

Device configuration profile: receiver = 40 MHz bandwidth, I/Q rate = 61.44 MHz, transmitter = 40 MHz bandwidth, I/Q rate = 61.44 MHz, device

clock = 38.4 MHz, and an internal LO is used for all measurements. Measurements are at nominal power supply voltages. All RF specifications

are based on measurements that include PCB and matching circuit losses, unless otherwise noted. Specifications are applicable over the

lifetime of the device.

50 MHz LO

The temperature settings refer to the die temperature. All LO frequencies are set to 50 MHz, unless otherwise noted.

Figure 4. Receiver Absolute Gain (Complex) vs. Gain Index, Baseband

Frequency = 5.6 MHz, ADC = High Performance, POUT = −9.6 dBFS

Figure 5. Receiver Absolute Gain (Complex) vs. LO Frequency, Baseband

Frequency = 5.6 MHz, ADC = High Performance, POUT = −9.6 dBFS

Figure 6. Receiver Noise Figure vs. Gain Index, Baseband Frequency =

5.6 MHz, ADC = High Performance

Figure 7. Receiver Noise Figure vs. LO Frequency, Baseband Frequency =

5.6 MHz, ADC = High Performance

ADRV9002BBCZ 데이터시트(PDF) 26 Page - Analog Devices