DWM1001 Module Development Board Datasheet

© Decawave Ltd 2017

Subject to change without notice

Version 1.3

Page 11

6

The Power Supply takes its input from USB or from a Battery or from a connected Raspberry Pi. It powers the

module and the other devices on the Module Development Board. It can also charge a connected battery when

powered by USB or the Raspberry Pi.

The Battery Charger is a Lithium - Ion battery charger. Batteries can be connected to the module development

board at the connectors shown in Figure 12.

Figure 12: Picture of the module development board showing the battery connection points and buttons

7

There are two buttons on the PCB, SW1 and SW2. SW1 is connected to the RESETn pin on the DWM1001

functionality when a tag is in low-power mode, as described in the System Overview document[3]. Buttons are

Positive

Battery

Connection

Buttons

connected to

DWM1001