PL-USB-BLASTER-RCN datasheet(10/17 Pages) INTEL

10 / 17 page

3.2.1. Installing on Red Hat Enterprise 4 or Earlier Versions

1. Add the following lines to the /etc/hotplug/usb.usermap file:

#Intel FPGA Download Cable

usbblaster 0x03 0x09fb 0x6001 0x0 0x0 0x0 0x0 0x0 0x0 0x0 0x0 0x0

usbblaster 0x03 0x09fb 0x6002 0x0 0x0 0x0 0x0 0x0 0x0 0x0 0x0 0x0

usbblaster 0x03 0x09fb 0x6003 0x0 0x0 0x0 0x0 0x0 0x0 0x0 0x0 0x0

2. Create a file named /etc/hotplug/usb/usbblaster and write:

#!/bin/sh

#Intel FPGA Download Cable hotplug script

# Allow any user to access the cable

chmod 666 $DEVICE

3. Make the file executable.

Now you can set up the programming hardware in the Intel Quartus Prime software.

3.2.2. Installing on Red Hat Enterprise 5 and 6

1. Create a file named /etc/udev/rules.d/51-usbblaster.rules

2. In the file, add the following lines, depending on the type of download cable.

Ensure that all the code is in one line.

— Intel FPGA Download Cable:

BUS=="usb", SYSFS{idVendor}=="09fb", SYSFS{idProduct}=="6001",

MODE="0666"

BUS=="usb", SYSFS{idVendor}=="09fb", SYSFS{idProduct}=="6002",

MODE="0666"

BUS=="usb", SYSFS{idVendor}=="09fb", SYSFS{idProduct}=="6003",

MODE="0666"

— Intel FPGA Download Cable II:

BUS=="usb", SYSFS{idVendor}=="09fb", SYSFS{idProduct}=="6010",

MODE="0666"

BUS=="usb", SYSFS{idVendor}=="09fb", SYSFS{idProduct}=="6810",

MODE="0666"

Now you can set up the programming hardware in the Intel Quartus Prime software.

3.3. Setting up the Intel FPGA Download Cable Hardware in the

Intel Quartus Prime Software

1. Launch the Intel Quartus Prime software.

2. Click Tools > Programmer.

3. Click Hardware Setup.

3. Using the Intel FPGA Download Cable

UG-USB81204 | 2020.03.11

Intel® FPGA Download Cable User Guide

Send Feedback

PL-USB-BLASTER-RCN 데이터시트(PDF) 10 Page - Intel Corporation